Assa Abloy Corbin Russwin AUX188 User manual

FM489 04/20
Installation Instructions
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information
go to www.P65warnings.ca.gov.
Dogging Indicator
(AUX188)
FE6600 and MP6600 Series
Side View
Pin
Control Fingers
Front View

2
Dogging Indicator (AUX188)
Installation Instructions
FE6600 and MP6600 Series
FM489 04/20
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
TOC Table of Contents
1 Dogging Indicator Installation ...................................................3
a Latch Door ......................................................................3
b Place Template ..................................................................3
c Drill Holes .......................................................................3
d Countersink Holes ...............................................................3
e Install Indicator..................................................................4
f Check for Proper Operation......................................................4

3
Dogging Indicator (AUX188)
Installation Instructions
FE6600 and MP6600 Series
FM489 04/20
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
1 Dogging Indicator
a Latch Door
Ensure door is latched and all bolts are projected.
b Place Template
Place plastic field template on pin in top rod through oval cut-out in door. (Figure1)
Figure1
Front View
Side View
Pin
c Drill Holes
Using a #7 drill bit, drill two (2) holes completely through door, making sure drill remains square to face
of door. (Figure2)
Figure2
d Countersink Holes
Countersink holes on opposite face of door to fit supplied oval head
screws. (Figure3)
Figure3

Corbin Russwin is a brand associated with ASSA ABLOY Access and Egress Hardware Group, Inc., an ASSA ABLOY Group company.
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
Corbin Russwin, Inc.
225 Episcopal Road
Berlin, CT 06037 USA
Phone: [phone]
Fax: [phone]
www.corbinrusswin.com
FM489 04/20
1 Dogging Indicator (cont.)
e Install Indicator
Install indicator on inside of door with supplied 10-24 x 2” oval head screws. Make sure that control
fingers grab top rod pin. (Figure4)
Figure4
Side View
Pin
Control Fingers
Front View
f Check for Proper Operation
Rotate lever until indicator window shows a single latch point. (Figure5)
Figure5
Indicator Window
Single Latch
Point
3-Latch
Points
Note
To dog top and bottom latches in retracted state, fully rotate lever and move slider on indicator
to left.