Note: Waste electrical products and batteries should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Issue No. 1A
Information and illustrations are subject to change.
Yale reserves the right to alter the specification and
product design at any time without notice.
Sleep Timer
The PIR features an automatic “sleep time” of
Once the PIR has detected motion, the PIR will
not retransmit for 1 minute. Any further motion
detected within this one-minute sleep period will
extend the sleep time by another minute.
LED indicator
Off Normal operation
LED flash
(2 sec)
When motion is detected and the
LED flashes for 2 seconds, this
indicates one of the following:
• Low battery
• Tamper switch activated
• PIR in ‘Test Mode’
Environmental conditions:
-10c to 40c , relative humidity 85%
non-condensing. Indoor use only
Radio:
868MHz FM
Motion Detection Range
110o
Compatible with Yale ‘SR’ and ‘EF’ Series
Alarm Kits.
Supervision Enable/Disable Jumper 2
If enabled, the PIR will automatically transmit
Supervisory signals periodically to the Control
Panel or Smart Hub at random intervals. The
Control Panel or Smart Hub needs to have
supervision enabled before it can monitor these
periodic signals.
Jumper On = Supervision Disabled (Default)
Jumper Off = Supervision Enabled
Motion High/Low Sensitivity Jumper 3
Jumper On = Increase PIR sensitivity to motion
Jumper Off = Decrease sensitivity (Factory Default)
Operation Specification
