5
HALO®LITE2™Installation Manual
Section 3. Installation
3.1 Mounting
The HALO LITE2power supply mounts using a
“keyhole”mounting system, as shown in Figure 2.
Figure 2. Power Supply Keyhole Mounting (back)
1. Identify a suitable installation location.
NOTE: The distance between the Halo LITE 2 controller
and the App should be less than 15 meters for a
reliable Bluetooth connection.
2. Insert the two mounting screws into the wall 60mm
apart. Use the two plastic masonry plugs (provided) if
mounting into masonry.
3. Hang the power supply on the two screws by the
keyhole mounts. Ensure that the power supply drops
down into place and locks in position.
3.2 Power Connections
To connect your lights to the power supply:
1. Insert Halo light cable wires into the green terminal
plug, see Figure 3. Wires can go into either socket,
there is no polarity.
2. Tighten screws on top to secure.
Figure 3. Power Supply Connectors
3. Insert each green connector into the bottom
of the HALO LITE2controller, in any available
position.
4. Plug the HALO LITE2controller mains cable into a
mains outlet to power on.
Section 2. System Overview
2.1 Kit Contents
The HALO LITE2controller allows you to control your
pool lights via the Halo Lite App.
Before starting, check that you have the correct parts as
shown in Figure 1. If any parts are missing or incorrect,
please call your local distributor or technical support at
1300 186 875 for assistance.
a
b
c
d
Halo LITE kit contents
a. HALO LITE2controller
b. Power supply terminal plug (2)
c. Screws 8G 3/4 (2)
d. Masonry plug 8G 25mm (2)
Figure 1. Kit Contents
