DO NOT DISCARD – GIVE TO USER
WARNING
PLEASE DO NOT RETURN ANY PRODUCT
Page 1
Model: Product Type:
9472 162-PIECE BUTANE MICRO PENCIL
HEAT-SHRINK TORCH KIT
When unpacking, check the parts diagram and part number
listing on page 2 to make sure all parts are included. If any
parts are missing or damaged, please call your distributor.
Unpacking
Study, understand and follow all instructions provided with this
product. Read these instructions carefully before installing,
operating, servicing or repairing this tool. Keep these instructions
in a safe accessible place.
INTENDED USE OF THE TOOL
162-PIECE BUTANE MICRO PENCIL
HEAT-SHRINK TORCH KIT
PRODUCT INFORMATION:
SPECIFICATIONS:
MADE IN TAIWAN
• 2-in-1 gas powered pencil heat gun and soldering
iron
•Use with tip to solder, or remove tip for heating
• 1.5mm to 15mm heat shrink tubes
1 PC - 9471 Butane Micro Pencil Soldering Iron
1 PC - 15mm Wide 50 CM Black Heat Shrink Tube
60 PC - 1.5mm Heat Shrink Tubes
35 PC - 2.5mm Heat Shrink Tubes
25 PC - 3.5mm Heat Shrink Tubes
20 PC - 5mm Heat Shrink Tubes
10 PC - 6mm Heat Shrink Tubes
10 PC - 10mm Heat Shrink Tubes
1 PC - Transparent Cap
This Kit is designed to heat solder and heat shrink tubing
for the purpose of electrical wiring repair. Do not use this
tool outside of the designed intent. Never modify the tool
for any other purpose or use.
•Use of this product can expose you to chemicals including
ethylene glycol, gasoline vapors and engine exhaust, which
are known to the State of California to cause cancer, birth
defects, or reproductive harm. Always wear ANSI approved
safety equipment, safety glasses and clothing when using
this product. Study, understand, and follow all instructions
provided with this product. Failure to read and follow all
warnings and operating instructions may result in
damages and serious injury or death.
•Always wear ANSI approved goggles when using this
product. (Users and Bystanders).
•Never use this tool for any application other than for which
it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
•Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with accessories
not designed for it could result in serious injury or death.
•Always select the correct accessories of the correct size
and design for the job that you are attempting to perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
•Do not begin repairs without assurance that vehicle is in
secure position, and will not move during repair.
WARNING
9471
