
vii
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions:
•  This device may not cause harmful interference, and
•  This device must accept any interference received including interference that may cause 
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with 
manufacturer’s instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by 
one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment to an outlet on a circuit different from that to which the receiver is 
connected.
•  Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required to 
assure compliance with FCC regulations. Changes or modications to this unit not expressly 
approved by the party responsible for compliance could void the user’s authority to operate 
this equipment.
Compliance Statement of Innovation, Science and Economic 
Development Canada (ISED)
This device complies with Innovation, Science and Economic Development Canada licence 
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device 
may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
Déclaration de conformitéde Innovation, Sciences et 
Développement économique Canada (ISED)
Le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement 
économique Canada applicables aux appareils radio exempts de licence. L’exploitation est 
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, 
et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le 
brouillage est susceptible d’en compromettre le fonctionnement.
CAN ICES-3(B)/NMB-3(B)