Atak AXF2650 User manual

AXF2650
26’’-50’’
100
Supports VESA sizes up to: 400x400

ATAK

1
2
Concrete Anchor
Ax4 Bx4 Cx4
K
N
EM4x30mm bolts
M5x20mm bolts
M5x30mm bolts
M6x25mm bolts
M4/M5 washers
M6/M8 washers
OSocket tool
Allen wrench
1
F
M4x20mm bolts
1
D
4
12
L
M
4
4
4
4
4
4
4
G
H
1
2
1
2
Wall Plate
Left & Right brackets M8x25mm bolts
M8x45mm bolts
I4 M6x40mm bolts
J
Brackets
Wall Plate

Fig. 1a
Center the Brackets (2) vertically on the rear of the TV. Attach the Brackets (2) to the rear of the TV
using four of the bolts (D-K) with the proper size washers (L-M) as shown in Fig. 1a. Tighten using
the Allen Wrench (N). Do not over tighten.
WARNING:
This mount is not to be used
with any flat panel
TV with a curved rear. This
mount is to be used only for
TVs with a flat rear.

65
Wood Stud Wall
Fig. 3a
2-1/2” (65mm)
Fig. 3b
Fig. 3c
four
.5
four A C

Concrete Wall
four
four A C
B
2.5” 65
are level and parallel.
four
Make sure the horizontal holes are no closer than 16”.
2.5” (65mm)
Fig. 3c
Fig. 3d
Fig. 3e
Step 4: Hang the television display
ATAK

3. As the TV swings down and the lower part of the brackets come in contact with the wall mount
plate, secure each bracket to the Mount plate by pulling down on the attached ribbon (one bracket
at a time) to open the spring-loaded lock (Fig. 4c). Release each ribbon to close and secure the
lock mechanism. Test each lock by pulling gently upward from the bottom of the TV. If the lock is
secure the TV will not pull upward.
Fig. 4a Fig. 4b
Fig. 4c
To remove the TV from the Wall plate pull down on each ribbon to release the security lock and
gently pull the bottom of the TV away from the wall, then lift the TV off the top of the Wall plate.
ATAK

This page blank

This page blank