AT&T 1465 User manual

Quick reference guide
Copyright © 2003 Advanced American Telephones. All Rights Reserved.
AT&T and the Globe Design are trademarks of AT&T Corp.,
licensed to Advanced American Telephones.
Telephone Base
Swivel antenna fully
upright for best results.
• MENU: Press to review or
change answering system
options.
• CHANGE: Press to change
a menu option.
• TIME/SET: Press to set
date and time.
• REC/MEMO: Press to
record a memo or outgoing
announcement.
• DELETE: Press to delete
message currently playing.
• REPEAT/SLOW: Press to
repeat message; hold to
slow playback.
• SKIP/QUICK: Press to
skip message; hold to speed
up playback.
• PLAY/STOP: Press to
retrieve messages or stop
playback.
• ON/OFF: Press to turn
answering system on or off.
• VOLUME: Press to adjust
message playback volume.
PAGE/HANDSET
LOCATOR: Press to
locate handset if lost.
SET CLOCK: Press
and hold to set clock.
NEW CALL: Lights when
new call has been received.
ATT-1465QSG-d03(OK).qxd 2/13/1950 7:21 PM Page 1

Quick Start Guide
2.4 GHz Cordless
Telephone/Answering
System 1465/1165
with Caller ID & Call Waiting
ATT-1465QSG-d03(OK).qxd 2/13/1950 7:21 PM Page 2

Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 12 hours before use. You can
keep the battery charged by returning the handset to the base after each use.
Plug power cord
transformer into
electrical outlet.
Plug long line cord
into telephone jack.
NOTE: Use only the power cord
supplied with this product. If you need a
replacement, call 1 800 222–3111.
Be sure to use an electrical outlet not
controlled by a wall switch.
NOTE: For wall mount-
ing, please see page 8 in your
User Manual.
Plug in battery here.
Charging light will be illumi-
nated while battery is charging.
Rotate antenna to
fully upright position.
Place handset in base to charge for 12
hours before first use.
Press coin into slot on base
of handset to release latch,
then remove cover.
To replace cover:
1Insert tabs at top of
cover into slots on
base.
2Align tab at bottom
of cover with slot in
base, then press to
click in place.
ATT-1465QSG-d03(OK).qxd 2/13/1950 7:21 PM Page 3

Quick reference guide
Select
Press to store a programming
option, or to store a directory
entry in memory.
Off
During a call, press to hang up.
During programming, press to exit
without making changes.
Hold
Press to place a call on hold. Press
again to resume your call.
^V Volume/Function
During a call, press ^V to adjust
listening volume.
While programming, press to change
menu item or value.
Press DIR when phone is not in use
to display phone book entries. While
entering or modifying names, press to
advance cursor.
Press CID when phone is not in use
to display Caller ID information.
While entering numbers or letters,
press to delete last character
entered.
Phone/Flash
Press to begin a call, then dial a
number.
During a call, press to receive an
incoming call, if Call Waiting is acti-
vated.
Chan/Delete
If call is noisy or unclear, press
to switch to a clearer channel.
Press and hold to delete all
Caller ID entries.
Prog
Press to customize the telephone’s
operation (see User Manual).
Redial/Pause
Press to display last number
called.
While dialing or entering
numbers into your phone
directory, press to insert a
4-second dialing pause.
Press once to enter “A”
Press twice to enter “B”
Press 3 times to enter “C”
Press 4 times to enter “2”
2
NEW 00 OLD 27
0 8/12 10:06 AM
Date and timeLow battery
Incoming calls
Handset
Using the dial pad to enter letters
ATT-1465QSG-d03(OK).qxd 2/13/1950 7:21 PM Page 4