Atdec AD-TVAC-SH75 User manual

AD-TVAC-SH75 Page 1 of 2
Installation Guide
AD-TVAC-SH75
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
! Failure to mount this product correctly may cause serious injury/death during or following installation.
! Do not over tighten screws.
! Product not suitable for use outdoors.
! After installation is complete, check to verify that Shelf is secure and safe for use.
! WARNING! Death or serious injury may occur when children climb on audio and/or video equipment furniture. A remote control or toys placed on
the cart may encourage a child to climb on the cart and as a result the cart may tip over on to the child.
COMPONENT CHECKLIST
A
Shelf
(x1)
D
Shelf Lip
(x1)
C
Shelf Connectors
(x2)
B
Shelf Clamp
(x1)
REQUIRED TOOLS
• Phillips Head Screwdriver
CAPACITY
0 - 11kg (0 - 24lb)

AD-TVAC-SH75 Page 2 of 2
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20220304
• Tighten fasteners and check the shelf is secure and safe to use at regular intervals (at least every three months.)
• Please contact your distributor if you have any questions.
1. Install shelf
ADJUSTMENTS
Height Adjustment
To set the height of the shelf, loosen the
screws slide shelf to preferred height and
re-tighten the screws.
MAINTENANCE
C
B
(x4)
A
D
1.1 Remove screws (x4) from Shelf clamp B.
1.4 Re-fasten screws through Shelf A.
1.6 Rotate the Shelf lip Dby 90° on Shelf Auntil it clips in.
1.2 Attach Shelf Connectors Cto inner column of
AD-TVC-75.
1.3 Insert Shelf Clamp Binto Shelf Connectors C.
1.5 Slide Shelf lip Don the Shelf A.