Atdec TH-3060-UF User manual

Display Mounting
Screws
Note:
Use a stud finder to accurately locate the centre of
the stud. Ensure that all screws fix securely into the stud.
Hardware
TH-3060-UF
Component Checklist
Wall Plate
Right Mounting
Bracket
IMPORTANT INFORMATION
! IMPORTANT - Install 3060 Wall Mount as per Installation Instructions.
! This product supports a maximum load of 50kg (110lbs).
! This product only supports displays with mounting hole configurations from 100mm wide x 100mm
high up to 600mm wide x 400mm high.
! The manufacturer does not accept responsibility for incorrect installation.
! Before installing this product, please check the display ventilation requirements with your
LED/LCD manufacturer.
Step 1. Check Components
Step 2. Mounting the Wall Plate
Tools Required:
Power Drill •
Tip: Use the built-in spirit level to ensure wall plate is horizontal
Masonry Wall Timber Stud
Check you have received all parts against the Component Checklist and Hardware above.
Nylon Anchor (x4)
M6 Washer (x4)
M5/M6 Spacer (x4)
M8 Spacer (x4)
Coach Screw (x4)
Left Mounting
Bracket
Nylon Anchor
Coach Screw
Wall Plate
M6 Washer
Timber Stud
Wall Plate
Coach Screw
M6 Washer
Multi-washer (x4)
M4x16/25/30mm (x4 each)
M5x14mm (x4 each)
M6x14/30mm (x4 each)
M8x 20/30mm (x4 each)
OR
Flat screen wall mount | Fixed
5mm ( ”) drill bit •Phillips Head screwdriver•
10mm (”) masonry drill bit
•10mm
(”) Socket Wrench or Shifter•
0.2
0.39
0.39
10mm (”) hole
depth: 55mm (2.2”)
0.39
5mm (”) hole
depth: 55mm (2.2”)
0.2
Installation Instructions

WALLWALL
Step 3. Attaching Brackets to Display
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 18/09/2015 ©
Lift your Display, hooking the Mounting
Brackets over the top of the Wall Plate Rail.
Pull down on the two Straps, and gently push
the bottom of the Display towards the Wall.
Release the Straps to engage the locking
mechanism, safely securing the Brackets to
the Wall Plate.
Step 4. Attaching/Detaching Display to Wall Plate (2 people required)
Step 5. Hide Straps
Installation Complete
Detaching Display from Wall Plate:
Pull down on both Straps to disengage the
locking mechanism. At the same time lift
the Display away from the Wall Plate.
Spacer
(optional, use only for
recessed mounting holes)
Mounting Screw
Multi-washer
Left Mounting
Bracket
Right Mounting
Bracket
Straps
PULL SECURE
RELEASE
Note: Make sure the TV is correctly hooked before
releasing the Display.
If necessary, shorten
the length of the Straps
using the hook-and-loop
fastener strip, so that
they cannot be seen.
TOP
HOOK