AudioQuest FLX 16-2 User manual

If you have any questions or concerns – please call AudioQuest at [phone]
or email: [email protected]
1
FLX 16-2, FLX 14-2
Bulk Spool Termination Manual
Thank you for choosing AudioQuest. This manual provides instruction for preparing
and terminating a bulk (unterminated) speaker cable.
Please be careful when using sharp tools. We recommend wearing safety glasses.
To terminate AudioQuest speaker cables you will need the following tools:
• Sharpknifeorrazorblade
• 1.5mm.Hex(Allen)wrench(suppliedwithSureGrip300,500&1000
Seriesspade&bananaplugs)
• SmallPhilipsscrewdriver(for500and1000Seriesconnectors)
We recommend using the following tools, which can be found at:
audioquest.com/accessories, then click “Tools.”
• Paladinjacketstripper
• Idealarticulatedwirestripper

If you have any questions or concerns – please call AudioQuest at [phone]
or email: [email protected]
2
Step 1
Measure about 5.5” of cable. Using a sharp
blade or a jacket cutter, carefully strip back the
outer jacket and remove. This will expose the
two conductor wires and two llers inside.
Step 4
Insert the Red wire into a red-stripe speaker
connector and tighten the connector’s screws
using a hex allen wrench. Insert the Black
wire into a black-stripe speaker connector and
tighten the connector’s screws using a hex allen
wrench.
Step 2
Using a wire cutter, remove the two thin black
llers. Be careful not to cut the conductor wires.
Step5
Ensure all connections are secure.
Step3
Using a wire stripper, remove ½” of insulation
from each wire.
FLX16-2&FLX14-2