Audiovox car connection 2.0 User manual

Mobile Version 1.0
User Guide

Installation Process
1. Make sure vehicle is in open view of the sky.
2. Plug device into OBDII port.
3. Start the vehicle–you should see the LEDs light up on the front of the device.
4. If for any reason you do NOT see the LEDs light up, with the device installed and engine
running, unplug the device and repeat steps 2 and 3.
5. Once you see the LEDs flashing –please leave the device plugged in for at least 5 minutes.
6. If your device has a SOLID Cellular light after 5 minutes - the SYNC process is complete.
If not, please POWER CYCLE (Instructions below) to restart SYNC process.
7. Once the SYNC process is complete –log into your Car Connection 2.0 MOIBLE APP
or WEBSITE to review location, vehicle and account information.
NOTE: Data may not appear on your account until you go for a drive.
Please follow these steps and the SYNC guide (next
page) in order to connect to Network & GPS –this
process may take up to 15 Minutes:
For more information, including FAQs, please visit www.CarConnection20.com
For technical assistance, please call 1-800-300-4550
HOW TO POWER CYCLE
1.
Un-plug device from OBDII port –for ~15 seconds
2.
Start your vehicle’s engine
3.
Plug device into OBDII port –with ENGINE RUNNING
4.
Wait approximately 5-10 minutes –
with ENGINE RUNNING
NOTE: Reference SYNC Guide for more information.
5.
Turn off vehicle/engine

LED Disconnected Time Plugged in: NA
Power: NO Synced: NO Data/GPS: NO
Installed: NO
N N N Engine: OFF
* Unplugging your CC 2.0 Device will UN-SYNC your device *
When SYNCED your CC 2.0 Device will connect “instantly”
?
LED KEY:
S = SOLID SB = SLOW BLINK FB = Fast Blink N = No Light
Power Cellular Ground
Syncing your Car Connection 2.0 device is a two step process. First you must plug the device into
your OBDII Port. After the installation, start your engine and follow the steps below to Sync your
device. If you are having connection issues –make sure your vehicle has a clear view of the sky.
Syncing Your Device
LED Time Plugged in: 2-5 Minutes
Ensure
POWER LED is ON, device is properly installed and
the
engine
is running. If your device has a SOLID Cellular light
after
5
minutes - the SYNC process is complete. If not, please
power
cycle
and continue.
FB FB FB
LED Syncing
Synced: NO Data/GPS: Possible
S SB SB
LED Sync Complete
Synced: YES NETWORK/GPS: YES
S S SB
LED Checking for Network
Synced: NO Data/GPS: Possible
S FB SB
00:00
?
Power Cellular Ground
Power Cellular Ground
Power Cellular Ground
Power Cellular Ground
Power Cellular Ground
?
POWER CYCLE TO BEGIN SYNCING PROCESS: ~5-10 Minutes
~5:00
5:01
~10:00
ATT ACTIVATION
SYNCING PROCESS
LED Checking for License
Synced: NO Data/GPS: NO
FB FB FB
Power Cellular Ground
POWER CYCLE TO
RESTART SYNCING PROCESS
SYNC PROCESS
~10:00
00:00
~5:00
Below is a chart to show you the two activation steps . When you first plug in your device, it must
first complete the At&tActivation process will need to go through each state before it is capable of
tracking and reporting data. If you unplug your device, the syncing process must be repeated.After
sync is complete - GPS/Data may take ~10 minutes to upload.
STEP
1
STEP
2
Minutes
LED Checking for License
Synced: NO NETWORK/GPS: NO
FB FB FB
Power Cellular Ground
LED Checking for Network/GPS
Synced: NO NETWORK/GPS: SEARCHING
S FB SB
Power Cellular Ground
LED Syncing
Synced: NO NETWORK/GPS: SEARCHING
S SB SB
Power Cellular Ground ?
?
For more information, including FAQs, please visit www.CarConnection20.com
For technical assistance, please call 1-800-300-4550
00:00

Downloading the CC 2.0 App
The Car Connection 2.0 application is available for all
Android and iOS powered devices. Please navigate to the
Google Play or App Store and search for “CarConnection 2.0”
(No space between car and connection). Once you have found
the correct application, download and install onto your device.
When it has finished installing, please open the application and
continue by logging in with your Car Connection 2.0 username
and password that you previously created.

Activate your Device
1. Open the Car Connection 2.0 App
2. Touch ‘Activate’ to start your
Device Activation
3. Enter Device IMEI and Click
‘Check’ to continue
4

Activating your Device
4. Register your account:
*Please note that you cannot change your username
after creation*
*Password must include at least one letter, one capital
letter, one special character, one number and be at
least 8 characters long*
*Insurance selection is optional*

Activating your Device
5. Completing the form will send a registration email to the
associated account. Log in to that email account and follow the
‘Registration Link’
6. After clicking the link you will be redirected to the Car Connection
2.0 Log In page –Log In on your Mobile Device or on the web
using your previously created Username and Password
•http://www.carconnection20.com/login/
6

Activating your Device
7. Please review the End User License Agreement and click
“Agree” to continue.

8. Once you log into the mobile app
for the first time –you will be
asked to enter Vehicle and Driver
information. This vehicle and driver
will be associated with your device.
9. Once you are finished touch ‘Save’
to continue.
Activating your Device
10. Finally, power the device to associate it with your account.

Your Dashboard

Your Dashboard
1. Profile Name
Name of account holder.
2. My Points
Touching here will open the My Points section.
Here you can review your points, where they
came from and how you can use them.
3. Profile Picture
This is the profile picture. By clicking the picture
you can choose a picture from you phone or
upload one from the internet.
4. Message Center
Touching here will open the Message Center.
You can easily see if you have messages by
looking at the Notification Bubble.
1
3
4
2
10

Your Dashboard
This is the My Scores section of the Dashboard. My Scores are broken
into four sections; Health, Driver, Emissions and Fuel. Each of these scores
are affected by your daily driving habits. My Scores are affected by all
vehicles associated with your profile. My Scores can range from 0 –100 and
will change color based on severity - Green (Good), Yellow (Possible Issues)
and Red (Needs Immediate attention). Each score is a button, by pressing a
score you will be directed to the corresponding Tab in the My Vehicle section.

Your Dashboard
1. Compare / See All
WORDs ABOUT THIS BUTTON.
2. Vehicle Picture
This is the vehicle picture. Clicking here will allow
you to choose a picture from you phone or upload
one from the internet.
3. Emergency
Touching here will open the Roadside Assistance
and Emergency Call section of the app.
4. Locate Now - Map
Touching here will open to a map of the selected
vehicles most recent location.
5. Optional Remote Access*
Touching here will take you to the Remote Access
section. From here you can unlock or even start
your vehicle.
* Existing remote access hardware required *
1
32 4 5

Your Dashboard
1. Social Media Connection
Touch the corresponding icon to post on your
scores or location on your favorite social media
sites.
2. See All Friends
Touching here will allow you to view all your
friends.
3. Friend Search
Touch here to open the friend search. You can
search for friends by their name.
1 32
13

My Points
3
2
1. Information Button
Touching here will provide details and information
about the My Points section.
2. My Points Breakdown
There are five areas where you can earn points;
My Health, My Driving, My Fuel, My Emissions
and My Friends.
3. Recent Points
In the recent points section you can view a log of
all the points you have gained, when you gained
them and why.
1

My Points
My Points are calculated as a daily percent of your Vehicle
Health, Driving, Fuel Economy and Emissions Scores. At the end of
each day you win 10% of each category that is a good (above 80)
score.
For example; if at the end of the day you have a vehicle health
score of 100, a Driving score of 93, a Fuel Economy Score of 82
and an Emission Score of 77 then you would win 10 Vehicle Health
points, 9 Driving Points, 8 Fuel Economy Points and 0 Emission
points.
You also win a percent of your Friends’ total score each day. At
the end of each day you win 5% of each friends’ score that has a
total score above 80.15

Message Center: Vehicle
1 2
1. Message Dropdown
Touch the corresponding section to view
detailed messages. If there are messages
pending you will see a red circle with an
exclamation point.
2. Message Description
Here you will se detailed descriptions of the
message or messages in the specific section.
You can also see the date and time the message
was sent.
If there are no messages a Green Check Mark
will show.

Message Center: Clearing Messages
1 2
1. Tap Maintenance or Vehicle
Recalls to View Messages
The drop down will show all Maintenance and
Recall messages for all vehicles in your account.
2. Tap the Message You want to Clear
A Clear Maintenance/Recall message will pop up.
3. Clear Maintenance/Recalls
In order to clear your maintenance and recall
messages you will need to enter the Odometer
reading and date from when the action was
preformed.
3
17

Message Center: Driver
1
3
2
1. My Driving Scores Graph
This graph will display and compare all drivers
associated with the account.
2. Time Interval
Touch the corresponding time interval to see
how your driver score changes.
3. Notification Log
Scroll through the log in order to see all driving
infractions, a description of the infraction and
time/date they occurred.
18

Message Center: Social
This is the Social section of the Message Center. Here you will see Nudges
from your friends. If a friend has a better Health, Driver, Emission or Fuel
score they can Nudge you in that category. You can also Nudge your friends!
Nudging give both you and your friends points.
To Nudge friends navigate to the Dashboard and tap ‘See All’ to view your
friends –tap a specific friend to see if you can Nudge them for their lower
Health, Driver, Emissions or Fuel score.
Name: Rob Mahrle