Audipack P4621 User manual

LED installation manual
What do you need:
Needed for installation:

Standard roof panel Left and right panel with drilling/cutting template aligned
to the aluminium profiles
Use the template to cut
and remove the upper
foam part of the panel
Scrape away foam and glue
Panel preparation
Important note:
The power plugs in the panel are centered from the
middle, at the front of the panel
1.
2.
3.

Position the template on the top of the panel and rill the hole
with a 12.5 mm drilling bit (always check the corresponding
drill diameter with the plug).
Insert the power plug with glue in the hole and let it dry
Drilling
Important note:
The exact position of the power plugs in the
panel does not need high accuracy.
4.
5.

Position the LED bar on
the panel and solder the
wires to the power plug.
Solder the + and –to the
correct contacts.
LeD installation and electrical
Install the LED bar with
the supplied double
adhesive tape.
Clean the surface, and
insert the pre-glued
isolation material in the
panel.
6.
7.