Audyssey APM1 User manual

Audyssey Professional Microphone 1
User Guide for MultEQ-X

APM1 for MultEQ-X User Guide
Revision 1  2022 Audyssey Laboratories Inc Page 2 of 5
Overvie :
This guide provides details for using the APM1 microphone from the Audyssey Custom Installer ith
MultEQ-X compatible AV receivers. The guide assumes access to an APM1 microphone, ACP2
calibrated preamp and supplied cables plus a CIK0021 RCA – 1/8” Mic Adapter.
APM1 Microphone & Stand:
ACP2 Calibrated Preamp:
Mini XLR Cables:
Mini XLR to RCA Adapter Cable:
RCA Line – 1/8” Mic Adapter:

APM1 for MultEQ-X User Guide
Revision 1  2022 Audyssey Laboratories Inc Page 3 of 5
Connecting Components:
A. Connect a mini-XLR cable to the microphone.
B. Place the microphone stand upright and extend the boom arm. Attach the microphone holder to the
end of the boom arm. Insert the microphone into the holder so it points to the ceiling.
C. Connect the mini-XLR cable from the microphone to the input (MIC IN) of the microphone preamp.
D. Connect another mini-XLR cable to the output (LINE OUT) of the mic preamp. Connect the mini-XLR-to-
RCA adapter to this mini-XLR cable.

APM1 for MultEQ-X User Guide
Revision 1  2022 Audyssey Laboratories Inc Page 4 of 5
E. Connect the RCA connector from the mini-XLR-to-RCA adapter to the RCA socket of the RCA-to-1/8”-
mic adapter.
F. Connect the 1/8” connector of the RCA-to-1/8”-mic adapter to the mic input jack of the AVR.
Warning - Do not extend the cable from the 1/8” adapter to the AVR. If more distance bet een the
microphone and AVR is required use additional mini-XLR cables bet een the microphone and preamp.
MIC IN
C
D
E
E
F
F

APM1 for MultEQ-X User Guide
Revision 1  2022 Audyssey Laboratories Inc Page 5 of 5
Usage:
•Do nload and install the MultEQ-X application from the Microsoft store:
https:// .microsoft.com/store/productId/9P0SMVDTVHQJ
•Refer to the MultEQ-X manual for instructions to Sign-in, purchase an AVR license and connect
to an AVR.
•On the ‘Measure’ or ‘Adjust Sub Levels’ page select ‘Add Ne Mic’:
•Select APM1 and enter the serial number of your APM1 microphone in the serial number box:
•Click the ‘Do nload Mic File’ button. After a short time the status should sho that the mic file as
do nloaded successfully. If there is an error check that the serial number is entered correctly and your
connection to the internet.
•Click the ‘Add Microphone’ Button. The do nloaded microphone file ill be available and selected in
the microphone selection drop-do n, and is no ready to perform measurements.