Aura SW-377W User manual

SW-377W
AURA
2 Solar Frosted
Dome Lights
Instruction Manual
PRODUCT DISPOSAL
NiCd battery must be recycled or disposed of properly.
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
“Ryobi takes the care of our environment very seriously. Please dispose of all waste electrical
and electronic equipment in a responsible and environmentally friendly way.”
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
210mm
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
BATTERY REPLACEMENT
Cd
1Unclick by turning top of Solar
light clockwise
2Remove top of solar light
3Turn power switch to OFF
4Open battery compartment
5Remove old battery
6Insert new battery
(ensuring + terminal meets
with + battery end)
7Close battery compartment
8Turn power switch to
ON / Auto
9Replace top of solar light
10 Turning top of solar light anti
clockwise until it clicks back
into place
CAUTION
Please be aware children should not use these as toys and care should be taken at all times.
The Fine Lighting Company International Ltd.
Medina House, Fieldhouse Lane, Marlow, Bucks SL7 1TB
Tel: [phone] Fax: [phone]
Email: [e-mail]
Web: www.thefinelightingcompany.com
Technical Helpline: 01628 894 500
X 2
NiMH
+-
+-
OFF
POWER
AUTO
1.2V/ 350mAh NiMH
OFF
POWER
POWER
AUTO
All of the Fine Lighting Company™ products
include a 1 year warranty The Fine Lighting
Company™ reserve the right to change images,
specifications and prices without prior notice.
DECLARATION OF CONFORMITY
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardized
documents.
Applicable EC Directive:
EC Directive of electromagnetic
Compatibility (89/336/EEC) with
amendments
Applicable Harmonized Standard:
EN55015/A2:2002
EN61547/A1:2000
EN61000-6-3/A11:2004
Model: SW-377W
Description: 2 Solar Frosted Dome Lights
Mark Pearson – Managing Director

SW-377W
AURA
2 Solar Frosted
Dome Lights
The solar light comprises of a solar cell,
rechargeable batteries and LED light
source. Light from the sun charges the
batteries during the day and at night the
energy stored in the batteries is used to
power the light.
The length of time the light stays on for
is dependent on the amount of sunlight
the solar panel has been exposed to
during the day.
No other power source or connections
are required.
PACK CONTENTS
• 2 x Solar light units (A)
• 2 x Post pipe in 27cm (B)
• 2 x Connectors (C)
• 2 x Post pipe in 20cm (D)
• 2 x Ground spikes (E)
WARNING
Do not apply pressure to the solar panel.
PRIOR TO USE
Check the pack contents to make sure you
have all the products listed.
Set power switch to "OFF" position and allow
battery to charge for 2 days under full sunlight.
Repeat this procedure every three months to
top up the battery. Please note, this may take
longer if there is not constant full sunlight.
Decide on an appropriate location for your
product (see Siting Instructions opposite)
ASSEMBLY INSTRUCTIONS
1Insert Solar light unit into 27cm post pipe
2Then insert connector piece into 27cm
post pipe
3Push 20cm post pipe onto connector piece
4Insert ground spike into free end of 20cm
post pipe
SITING INSTRUCTIONS
Solar lights are designed for use outside in an
open (un-shaded) location
The solar light should be located where sunlight
can fall directly on the unit. Shadows from
buildings, trees, walls, hedges or similar should
be avoided as these will reduce your light
running time.
Avoid locations where light from other sources
will fall on the panel at night (street lights,
floodlights etc) as this may prevent the light from
turning on.
The units can be left outside in the rain but
should not be exposed to water jets or
immersed in any way.
For optimum life, the solar panel should be
protected from weather extremes such as snow
or frost
Do not position near direct sources of heat such
as patio heaters or barbeques
The Solar panel is designed to be placed where
the ground is soft so that the ground spike can
be pushed in easily.
CARE & USE
Periodically wipe clean with a soft dry cloth.
Never use scourers, abrasives or chemical
cleaners. Do not allow water to come into
contact with electric components.
The solar panel lens should be cleaned
periodically to ensure its efficiency is not
reduced by dust and dirt.
Some condensation may form inside the lights
or solar panel in cold conditions. This is normal
and will not affect the performance of your light.
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
210mm
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
210mm
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
210mm
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
PRODUCT SPECIFICATIONS
Product Size 11.4cm (L) x 11.4cm (W) x 60cm (H)
+ 9.5cm (spike)
Solar Cell 0.16W Amorphous
Light Source Type 1 x white LED (per unit)
Laser Classification Class 1
Surface Material Stainless Steel
Battery Type 1 x 1.2V NiCd (AA) 600mAh (per unit)
Maximum UK operating Time (summer) 8 hrs
Maximum UK operating Time(winter) 3 hrs
Maximum operating Time (full charge) 12 hrs