Atom HOVER Assembly instructions
This product may contain substances that can be hazardous to the environment if not
disposed of properly. Electrical and electronic equipment should never be disposed of with
general household waste but must be separated of it’s correct treatment and recovery.Where
possible recycle your packaging. Please keep these instructions safe for future reference.
120W, 150W and 200W IP65 LED Highbay.
INSTALLATION SHEET
LED highbay
HOVER
Product Range
safety INFORMATION
• Luminairesmustbeinstalledandttedbyaqualiedelectrician
ensuring the installation complies to the current wiring regulations.
• Alwaysswitchoffthemainssupplybeforeinstallationorservicing.
• Ensure all electrical connections are secure and that there are no
loose strands.
• Iftheexternalexiblecableorcordofthisluminaireisdamaged,
itshallbeexclusivelyreplacedbythemanufacturerorhisservice
agentorasimilarqualiedpersoninordertoavoidahazard
• Thelightsourceofthisluminaireisnotreplaceable;whenthelight
sourcereachesitsendoflifethewholeluminaireshallbereplaced.
• TheAtomHighBaylightissuppliedwithaØ25mmsteeleye-bolt
specicallyprovidedforsuspendedinstallation.DONOTsubstitute
theeye-boltwithanyotherttingasthiseye-bolthasbeentestedto
safelybeartheweightofthelight.
• WARNING:CAUTION-RISKOFELECTRICALSHOCK
ProductSpecication
Voltage 220-240V~50Hz
Power consumption 120W 150W 200W
Light colour options Daylight
Lumen output 16255lm 21425lm 27560lm
Colourtemperature 5000K
Colourrenderingindex >80
Beam angle 120°
Dimmable 1-10V Dimmable
Warranty 5 Years
Working temperature -30°C – 45°C
IP Rating IP65
Electricalclassication Class I
Flexandpluglength 1.5m
Installation
The Atom High Bay light is supplied with an SS304 grade Ø25mm
steel eye-bolt specifically provided for suspended installation. DO NOT
substitute the eye-bolt with any other fitting as this eye-bolt has been
tested to safely bear the weight of the light.
1. Remove the light from it's packaging and inspect for any signs
of damage, particularly to the supplied flex and plug. Should any
damage be visible, immediately return the product to place of
purchase. DO NOT dismantle the light or attempt to repair.
2. Select installation point on ceiling or overhead support structure
and securely mechanically fix suspension chain/rod/wire. The use
of adhesives or double-sided tape is NOT recommended.
DO NOT SUSPEND THE FITTING VIA THE MAINS CABLE. Ensure
that, once installed the mains cable can comfortably reach the
mains power outlet without any tension on the cable.
3. Attach fitting to end of suspension chain/rod/wire with the eye-bolt
and plug mains cable into power outlet. The High Bay light is ready
for use.
1-10VDimming
An extra connection cable is provided on your highbay driver for interface
of a 1-10V dimming signal from a control system or sensor.
When not in use, cable should be left secured in place.
Inspect for any signs of damage
Particularly to the supplied mains cable
1
2
Select installation point and securely
mechanically fix suspension chain/rod/wire
3
Attach tting and plug mains cable
into power outlet
Model SKU Wattage
HOVER/16022 16022 120W
HOVER/16023 16023 150W
HOVER/16024 16024 200W
172mm
53mm
Ø239
174mm
55mm
Ø271
Dimmable
blue brown purple whiteDIM+
white blue gray blackDIM-
Warranty
Atom products are distributed in Australia by Evolt Pty Ltd ('us', 'our', or 'we'). Our
contact information is set out in the bottom leftt hand corner of this page.
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
In addition to your guarantees under the Australian Consumer Law, our goods
also come with a contractual warranty, which is described below. This warranty is
additional to your rights under the Australian Consumer Law (and any other rights
or remedies you may have under a law in relation to the products) and is not
intended to modify or exclude those rights.
Subject to the terms of this contractual warranty, if your Atom products are
defective, we will (at our election) repair or replace the Atom products. Once
we make this election (and take the relevant action), we will have honored our
obligations under this contractual warranty.
Our total liability under this warranty is limited to the cost of repair or replacement
of the defective product (at our election). We otherwise exclude all liability in
relation to the product to the fullest extent permitted by law (noting our comments
above regarding the Australian Consumer Law and any other rights or remedies
you may have).
If you wish to claim under this warranty, you must, at your own expense, return
the product or that part of the product which you believe is defective, together
with proof of original purchase, your name, address and telephone number and a
certificate of installation (or other document required by the law for the installation
of electrical products in the place in which the product was installed) to Evolt at
the address set out in the bottom left hand corner of this page within the warranty
period. You bear all costs associated with claiming under this warranty (including,
but not limited to, postage costs). Without limiting the preceding sentence,
this warranty does not apply to the costs of the removal or re-installation of the
defective product.
The warranty period for this product is five years from the date of purchase.
This warranty is not transferable and is only given to the original purchaser of the
product, provided the purchaser has purchased the product from us.
Proof of purchase must be provided to us with any warranty claim. We
recommend that you attach your proof of purchase to your product manual.
This warranty does not apply to consumable items within your product (including,
but not limited to, lamps or batteries). This warranty does not apply to products
that have been improperly stored, installed, or used. This warranty does not apply
to products that have not been maintained in accordance with the instructions
contained within this product manual.
This warranty does not apply to loss or damage caused by wear and tear, misuse,
incorrect installation or operation, failure to clean and maintain, incorrect voltage
or non-authorised electrical connections, adverse external conditions (such as
power surges and dips, acts of God, exposure to heat, corrosion, insect or vermin
infestation), use of non-authorised or defective parts or globes, or to items that
have been repaired than by a person other than us or a repairer approved by us.
1602205_V1.2
AtomisaregisteredbrandofEvoltPtyLimited.
For further information please call Evolt’s head office on 1300 4EVOLT (438 658).
Evolt Pty Limited PO BOX 271 KINGSGROVE NSW 1480
ABN 83 112 123 529
Due to changes in industry standards and Evolt’s policy of continual product development,
product specifications are subject to change without notice.
Images are for illustrative purposes only.
For more information please visit our website www.evolt.com.au
This manual suits for next models
3
Other Atom Lighting Equipment manuals
