AURES PS-400 User manual

Universal 2D Bluetooth
Scanner
PS-400
Quickstart Guide
Pairing Scanner Procedures
Step 1 : Connect the Cradle to the host computer via its USB
cable
Step 2 : Activate the scanner
To configure the scanner, press the Scan button and point the
scanner at below code to set the scanner to the Bluetooth-HID
(keyboard) mode. The scanner will beep three times quickly
and the LED will flash green when read correctly. The scanner
mode is now set.
Step 3 : Language Setting
(please hide the unused barcodes before scanning to improve
its reading accuracy)
For French,
For German,
For English,
Step 4 : Set for automatic Bluetooth reconnection
Scan all below barcodes from top to bottom.
ZZ
CA99
ZZ
Step 5 : Select the AURES BT Scanner in Windows
Press the Clear/Function button for about three seconds until the LED
blinks blue. The scanner is now in the Bluetooth pair mode.
To connect the scanner to your computer using Bluetooth, use the
following steps:
(1) Open Settings.
(2) Click on Devices.
(3) Click on Bluetooth & other devices.
(4) Turn on the Bluetooth toggle switch.
(5) Click the Add Bluetooth or other device button to connect a new
device.
(6) Select the Bluetooth option.
(7) Select the AURES BT Scanner.
(8) The scanner will beep once when paired successfully. It will then
show up on the list of devices in Windows.
To test if the scanner works, open the Windows Notepad and scan
below UPC code for verification.
Rel. 1.0 Jul20

WEEE Notice
The WEEE mark applies only to
countries within the European
Union (EU) and Norway.
This appliance is labeled in accordance
with European Directive 2002/96/EC
concerning waste electrical and
electronic equipment (WEEE). The
Directive determines the framework for
the return and recycling of used
appliances as applicable throughout the
European Union. This label is applied to
various products to indicate that the
product is not to be thrown away, but
rather reclaimed upon end of life per
this Directive.
Technical Support
The AURES Group thanks you for your
loyalty.
To download our most recent drivers
and utilities and obtain advice regarding
the installation of your equipment,
please visit the AURES Technical Support
Website:
www.aures-support.com/en
FCC Compliance Statement
(United States)
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
FCC ID: 2AUQFXXXXXX
Scan button
Clear/Function button
Front View Side View Rear View
Basic installation procedures
Non-Metallic surface (e.g. wooden table)
Metallic surface (e.g. Cash Drawer)
Either
(1a) Directly place the Cradle on the desk
without the plastic part if you don’t want
to fix it;
Or,
(1b) Tear off the Release Paper of the
Double Side Tape being pre-glued at the
bottom of Cradle Holder
Simply locate the Cradle on top of the
metallic surface and it will be
self-attracted properly
Or
(1c) Fix tightly two pieces of included
5/32 screws with the Cradle Holder
(2) Secure the Cradle onto the Cradle
Holder