Aurora Lite Bank Luma 800BI User manual

Portable LED Light for Photo and Video Shootings
Operation Manual

TABLE OF CONTENTS
1. Introduction
2. Safety Precautions
3. Specifications
4. Components and Accessories
5. Control Panel
6. Operating Instructions
7. Warranty
Safety Precautions
1. INTRODUCTION
This guide provides information on how to use the product functions to get the full effect and benefits
of LUMA 800BI led light, as well as warnings on its use. LUMA 800BI is designed for professional use,
for indoor shootings as well as outdoor shootings. To obtain the maximum features, please read the
following operating instructions very carefully before using the product for the first time. Please keep
these operating instructions for you and subsequent users to reference in the future.
2. SAFETY PRECAUTIONS
This equipment has been checked and meets the requirements of general safety for electronic devices.
These requirements are specified, to provide a reasonable protection against electromagnetic
interference, when the equipment is used in commercial environments.
This equipment generates, uses, and can emit waves of radio frequency, and if not properly used
following the instructions in this manual, can produce interference in radio communications.
The use of this equipment in residential areas can produce interference; the user will be the only one
responsible in correcting them.
1. Please read the following operating instructions very carefully, before using this fixture for the first time.
2. In order to protect against risk of electric shock, the installation should be properly grounded.
Non-compliance or using a non-grounded type plug will expose you to the risk of electric shock.
3. The lamp head emits heat through its vent holes in the housing and the housing surface can reach
a temperature around 60 ºC.
4. Do not use under ambient temperature below 0°C and over 40°C.
5. Do not attempt to open any of the device or component housings. To reduce the risk of electric shock,
do not remove lamp head cover. No user-serviceable parts are inside. Maintenance and repair work
to be carried out only by authorized Service Centre.
6. Do not store or use under humid or moist conditions for an extended amount of time.
7. Do not cover the vent holes while using it. Proper ventilation must be provided. Avoid exposing
the lamp head to the heat radiation of other light fixtures.
8. Keep this equipment out of reach of children.
For your own safety, please read and follow all safety instructions and warnings.
Exemption from Liability
The manufacturer, disclaims liability for any damage to persons or property caused by inappropriate
operation, damage of this kind lies in the responsibility of the operator.
Warranty
This product is manufactured to local specifications and the warranty is valid within the country of
purchase. Should the product fail or malfunction, while you are abroad, the manufacturer assumes
no responsibility for servicing the product locally or bearing the expenditure incurred thereof.
The total or partial reproduction of this guide is prohibited without the express written permission
of Aurora Lite Bank. Information and specifications in this document are subject to change without
notice. 2017 © Copyright Aurora Lite Bank. All rights reserved.
1

3. SPECIFICATIONS
LUMA 800BI is color temperature variable from 2700°K to 6500°K.
Carefully selected LEDs are used to ensure high intensity and high color rendering over 97Ra. As little as
B5 size and as thin as 4.5cm, LUMA 800Bi is light weight and portable for easy transportation.
Intensity and color temperature can be easily adjusted with a knob. Rotation knob clockwise will increase
value and rotation knob anti-clockwise will decrease value which one can see through LCD monitor
next to the knob.
When powered by LUMA 1000 battery pack, recharging from empty to full takes 4 hours and runs for
1.5 hours at max power and many more hours at min power.
Due to the front diffusion panel, direct light from LED sources get diffused creating soft and shadow
free output.
4-way barndoor comes complete with and optional accessories such as softbox, egg crate grids, and
carrying bag are available. Optional connect cable DC jack 2.5mm to D-tap enables use with
a household camcorder battery.
2
4. COMPONENTS AND ACCESSORIES
3
AC Kit
Optional Accessories
1. LED light head complete with 4-way barndoor
2. Tilting bracket
3. Recharger with 1.5m connect cable to power plug
4. 1.5m connect cable for recharger and power plug
5. LUMA 1000 battery pack with 1.5m connect cable head to battery
DC Kit
1. LED light head complete with tilting bracket and 4-way barndoor
2. Tilting bracket
3. AC power adapter with 1.5m connect cable with DC jack
4. 1.5m connect cable AC power adapter to power plug
1. Softbox with full stop diffuser
2. Louver(grid)
3. 1.5m connect cable DC jack 2.5mm to D-tap for use with a camcorder battery
4. Carry Bag

5
DC Kit
AC Kit
4
1. Control knob
- Push the knob down for a second to turn on
or turn off the device.
- Long push to turn on/off the device and short push
to change mode between color temp and intensity.
- Rotation to the right will increase value and rotation
to the left will decrease value.
2. Display window
3. DC jack 2.5mm
4. Overheat indicator
6. OPERATING INSTRUCTIONS
5. CONTROL PANEL
1. Remove all contents from the box. fig. 1
2. Loosen the tightening bolt on the tilting bracket. Place the open end of the tilting bracket
onto the stud of your light stand and tighten the bolt. fig. 2
3. To use with LUMA 1000 battery pack, plug one end of connecting cable to DC jack at
the light head and the other end i.e. 4-pin male XLR into the female connector on
the battery pack while pressing down the locking button above. fig. 3
4. For recharging, connect the battery charger to the battery pack, and connect the AC
power cord between the battery charger and a wall outlet. The RED LED indicator
on the charger will turn on while recharging and turn into green when fully recharged. fig. 4
5. When set up is done, turn on the power by pressing the control knob for a second.
Long push of control knob is to turn on the device or to turn off the device while short push
is to change the mode in between intensity and color temperature. fig. 5
6. Intensity as well as color temperature can be adjusted with the control knob. Rotation to
the right will increase value and rotation to the left will decrease value which one can see
through LCD monitor next to the knob. To change mode from intensity to color temperature
or vice versa, press the control knob shortly. fig. 6
7. To use with the AC power adapter, plug one end of connect cable to DC jack
at the light head and the other end to AC power adapter and then connect AC 1.5m
power cable cord between the AC power adapter and a wall outlet.
8. Ambient temperature must be kept between 0°C and 40°C. In case of higher ambient
temperature over 40°C, the device’s internal temperature can reach over 65°C which
will lead overheat protection circuit to operate and turn off the light automatically. Overheat
indicator will turn on red and warning sign “OVERHEATED LED SYSTEM COOLING” will
appear on the LCD monitor. Cooling fan will increase rpm to max. When the device is cooled
down, normal operation will get started automatically. You’re strongly advised to cool down
ambient temperature to avoid repeat operation of overheat protection circuit.

CONTACT
Address
123 Secheonro 3 - gil, Dasa - up,
Dalseong - gun, Daegu 42921
Republic of Korea
Phone & Fax
Telephone
Fax
+ 82 53 384 9874
+ 82 53 384 9886
Info
Made in Korea
Web
e - mail
www.auroralitebank.com
[email protected]
6
7. WARRANTY
LUMA 800BI is guaranteed to be free from defects in workmanship and parts and carries
an year warranty period from the date of purchase. Defects that occur within this
warranty period, under normal use and care will be repaired or replaced at Aurora Lite Bank
discretion, solely at our option with no charge for parts or labour. In the event of the
equipment malfunction, contact the dealer from whom you purchased the product.
Please note, that you will be not be reimbursed for the cost of bringing the equipment
to us or to our authorized dealers or to our service center. Aurora Lite Bank reserves
the right to replace the product or relevant part with the same or equivalent product
or part, rather than repair it. Where a replacement is provided the products or part
replaced becomes the property of Aurora Lite Bank.
This warranty applies only to LUMA battery pack kit and AC power adapter not to the
accessories, such as the barn doors, nor does it apply to fuses and other consumables
provided. Any consequential damages arising from failure of the equipment, such as
expenses incurred in taking pictures or recording images or loss of expected profit,
will not be reimbursed, whether they occur during the warranty period or not.
Parts essential to the servicing of the light equipment (that is, components required
to maintain the functions and quality of the fixture) will be available for a period of five years
after the product is discontinued.
This warranty does not cover any damage resulting from:
- Failure to follow the instructions in the instruction manual;
- Repair, modification or overhaul not conducted by any Aurora authorized
or approved personnel.
- Fire, natural disaster, act of God, lightning, abnormal voltage, etc;
- Submergence in water (flooding), exposure to alcohol or other beverages,
infiltration of sand or mud, physical shock, or dropping of the equipment
and other unnatural causes.
year