olympia electronics LLB-26/CBS/24V/ADR User manual

923026005_09_001
Page 1 from 5
TECHNICAL CHARACTERISTICS (for LED MODU LE Specifications see page 1)
Operation temperature range
Relative humidity
Construction materials
External dimensions
Typical weight
Guarantee
Mains voltage
Maximum power consumption
Degrees of cover protection
Produced in accordance with
Light source intensity
15-30V DC
o
-30 to 50 C
up to 95%
3 years
IP 44
300lm
2.5W
745 gr.
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547
Thank you for your trust in our products
Olympia Electronics - European manufacturer
GENERAL
1. Operations for installation, maintainance or
te st in g m us t b e d on e b y a ut ho ri ze d
personnel only.
2. The device, must be connected only to the
GR-8600 panel via its ADR line.
3. First set the address before installation. To
address the device see on page 5.
ADDRESS OPERATION
For address operations refer to the installation
manual of the panel. Please see manual of CBS
panel GR-8600 for maximum number of
luminaires that can be interconnected.
LED MODULE CHARACTERISTICS
Olympia Electronics S.A
45 °C max. across the board
Embedded on the main pcb
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
Z: Central supply
1: Maintained
C: Including inhibiting mode
G: Internally illuminated safety sign
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
13-14.5V DC
1.95W
2405185
LLB-26/CBS/24V/ADR
ADDRESSABLE EDGE ILLUMINATION SIGN
FOR GR-8600 CBS
240x35x179mm
Aluminum, ABS/PC, PC, Plexiglass
26 m
Viewing distance
LLB-26/CBS/24V/ADR

ELECTRICAL CONNECTIONS (after the mains interruption)
1
2
3
4
5
6
7
Unfasten the two side cover screws and remove the
plastic cap by sliding it gently.
Install the gaskets and make holes at the center of
each gasket by using a small screwdriver. Pass the
round cable through the gaskets.
Pass the communication cables through the holes
and connect them as shown in the picture when there
are other luminaires to be connected to the line
(minding the correct polarity).
If the luminaire you installed is the last one connect
the cable to one of the two inputs, as shown on the
picture (minding the correct polarity).
Address the device though the dipswitch according
to the table on page 5.
Replace the removed parts in the previous steps.
SURFACE MOUNTING ON A WALL (single sided)
Install the included plastic bracket on the wall (figure
1). Remove the aluminum bracket from the luminaire
and use the two supplied mounting screws to install
the aluminum bracket to the plastic bracket (figure 2).
Slide the luminaire to the aluminum bracket and use
the bolt on the center (*), to stabilize the luminaire
(figure 2).
CEILING MOUNTING (double sided)
Remove the aluminum bracket from the luminaire and
install it with the included spacers, screws and plugs in
the ceiling (page 3). Slide the luminaire to the
aluminum bracket and use the bolt on the center (*), to
stabilize the luminaire (figure 4).
Power on the device at the end of the installation (see
GR-8600 manual).
INSTALLATION INSTRUCTIONS
(*) First, hand tighten it and then,
use pliers to tighten it little bit
more (not all the way).
Page 2 from 5
1
2
3
+L -L
4
+L -L
Cable
entry
Screws
923026005_09_001
8
9

SURFACE MOUNTING ON A WALL (single side luminaire)
CEILING MOUNTING (double side luminaire)
MOUNTING METHODS
Place the included mounting screws
in these holes of the plastic bracket
Mounting screws 1, 3
Included spacers 4
Bolt 2
1
1 3
2
2
4 4
2 Mounting screws
Bolt
Figure 2. Side view
Figure 1
GENERAL!!
Measure the distance of the mounting holes and after
the drilling place on these spots the mounting plugs
and fasten the base with the mounting screws.
Figure 3. Front view
Figure 4
Aluminum
bracket
Plastic
bracket
Page 3 from 5
1
2
SIDE WALL CLEARANCE
Depending on the size
of the luminaire the distance
from the side wall
must be more than:
LLB 26: 440mm
Luminaire
Aluminium
braket
(a)
(a):
923026005_09_001

Page 4 from 5
FLAG MOUNTED ON A WALL (double side luminaire)
ALTERNATIVE MOUNTING METHODS
A-1135 SET, ONLY FOR PROFILUX-26
(OPTIONAL AFTER REQUEST)
HANGING INSTALLATION (double side luminaire)
A-1136 SET
(OPTIONAL AFTER REQUEST)
INSTALLATION PICTOGRAMMS
1.Unfasten the two screws of the luminaire. 2.Insert the pictogramm after removing
the protective film from the back side.
3.Carefully fit the top aluminium cover and reinstall the retaining screws.
923026005_09_001

Page 5 from 5
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
[email protected]
Addressing Table
Address Dipswitch
setting AddressAddressAddress Dipswitch setting
Dipswitch
setting
Dipswitch
setting
5
6
7
8
9
10
1
1
1
1
1
1
ON
ON
ON
ON
ON
ON
2
2
2
2
2
2
3
3
3
3
3
3
4
4
4
4
4
4
5
5
5
5
5
5
6
6
6
6
6
6
11
12
13
14
15
16
17
18
19
20
1
1
1
1
1
1
1
1
1
1
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
2
2
2
2
2
2
2
2
2
2
3
3
3
3
3
3
3
3
3
3
4
4
4
4
4
4
4
4
4
4
5
5
5
5
5
5
5
5
5
5
6
6
6
6
6
6
6
6
6
6
21
22
23
24
25
26
27
28
29
30
1
1
1
1
1
1
1
1
1
1
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
2
2
2
2
2
2
2
2
2
2
3
3
3
3
3
3
3
3
3
3
4
4
4
4
4
4
4
4
4
4
5
5
5
5
5
5
5
5
5
5
6
6
6
6
6
6
6
6
6
6
1
ON
23456
1
ON
23456
1
ON
23456
2
3
4
1
ON
23456
131
32
1
ON
23456
1
ON
23456
923026005_09_001