Aussie Fit SD Pro Quick guide

Pedometer Use Instructions.
Aussie Fit Sport Science
S>D PRO MODEL
D
MONTHLY PEDOMETER
• 5 Steps Filter Sensor
• Auto Reset For Day And Week
• DaylWeek/Month Records For
Steps/Distance/Kcalmmer
• Time Of Day
• Steps Taken To 399,999 Steps
• Activity Time
• Lap Timer
• Exercise Speed
• Delayed Reset Bullon
'i.I.] @3~'i:iIQ:jII'Mlj' 3: 1
1.To open the lid is to monitor the records
you exercised.
2.To work properly, pedometer case must
be closed.
.i·••. 1;ii:i#lM:f.~1ilt}3\~i3~ii
1.Decide first if you want to work in
Kilometers or Miles.
2.Hold the RESET bullon (A) for 5 seconds
to convert the displayed value from
Metric to Imperial unit or vice versa.
3.The originally displayed value will reset to
zero.
• i.l13i 11.1.1 ;J.i i;J i Ii #i
l"tetJFt4"i.lie:lal
1.Press the MODE bullon (D) to reach
DISTANCE mode.
2.Press the SET bullon (B) to show stride
adjusted.
3.Each repeated press of the SET bullon
increases stride by one cm (1inch). Hold
for rapid advance. For example: F3.11
means 3 feet 11 inches.
4.When personal stride is complete, the
display will return to original display after
3 seconds.
ia.t1:1aoZ.iii;i'h4td '.
fi lSFM((·I."$,'):i,ilbll
1.Press the MODE button (D) to reach
CALORIES mode.
2.Press the SET bullon (B) to show
presonal weight.
3.Each repeated press of the SET bullon
increases weight by 1kg (1Ib).Hold for
rapid advance.
4.when personal weight is complete, the
display will return to original display after
3 seconds.
A
B
c
1'·li:i'·:
1
:C3 ·I;3
1.Press the MODE bullon (D) to reach
CLOCK mode.
2.Press the SET bullon (B) to show time to
be adjusted.
3.Press the RESET bullon (A) to adjust
HOUR digit.
4.Press the SET bullon (B) to adjust
MINUTE digit.
5.Press the TOTAL bullon (C) to advance
WEEKDAY .
6.when the clock is set, the display will
return to original display after 3 seconds.
l#iU'Ii'[·Uf.1
Press the MODE bullon (D) repeatedly to
cycle through all five dual display
readings:
• STEPS
Lower display shows number of steps
taken to 399,999 steps.
Upper display shows SPM (average
number of steps per minute).
• DISTANCE
Lower display shows distance travelled
to 999.99 MILE or KM.
Upper display shows average speed in
MPH or KPH.
• CALORIES
Lower display calculates KCALS burned.
Upper display CPM (average calories
Consumption per minute).
·CLOCK
Lower display shows hours and mimutes.
Upper display shows seconds.
• TIMER (ACTIVITY TIME)
Lower display shows time used during
walk/run trips to 100 hours.
Upper display shows lap timer on each
walk/run trip.

•i•••. 1: [.I ( •• t 'b2. AA #I: M [":. i: I
I j ::(lloljlo}-1
Press the TOTAL button (C) repeatedly to
read day/week/month records of the
specified mode.
1.Day- To memory today's records
2.Week-To memory this week's records up
to now.
3.Month-To memory total days records.
Upper display shows the number of days
calculated.
'&t.'~llt.' itA 3 ;1., iJ ¥f.1:a I
1.Day-Press the RESET button (A) for two
seconds to reset trip/day records to zero.
2.Week-Press the RESET button for two
seconds to reset day/week records to
zero.
3.Month
a.Press the RESET button for two
seconds to reset day/week/month
records to zero.
b.On the first day of each month, resets
all records to zero to start new month's
program.
'· ii i.f~ @;I.I;J ~13i'
1.At 2:00am each day, the previous day's
records will auto reset to zero (but
display is still retained until 5 steps take).
2.At 2:00am each Sun, the last week's
records will auto reset to zero but still
remains on display. Walk 5 steps to start
new week's records.
'·Sli ("&["9 3&'3~.Ii 3~f.1·];,
1.To filter out random movements, the unit
remains in standby mode until five (5)
continuous steps are registered. Only
then are the 5 steps calculated in, and an
Active indicator A ••appears on the
upper left of display.
2.When regular walk/run movement stops,
after 2 seconds the timer pauses and the
unit switches to standby status (Active
indicator A disappears).
•i.' [email protected] [.]~. j: I €I R 3 .1'] ¢ I§i j 3;,
1.Clip the unit to your beIf or to the top of
your shorts, trousers or slacks as close
to your hip as possible.
2.The unit is vertical to the ground as this
will aid in proper function and make the
display easy to read.
l:ti,iAA;V·;JAA@ ·SdAA&lAA:·'
1.Remove two small screws securing the
front logo plate and lift oft the logo plate.
2.Remove and replace battery with LR44
type or equivalent. Be sure + side is up
when the battery is inserted into the
compartment.
3.Place front logo plate in its original
position and fasten the two screws.
4.Re-enter your stride length, weight and
set time of day.
5.Pedometer is not waterproof. Keep away
from any liquid.
6.Treat it carefully. Do not drop it,or expose
it to shock.
Aussie Fit Sport Science
Fair Dinkum Warranty
We are so confident in our pedometer quality we offer a three year warranty from the date of
purchase against any manufacturer defect when used as instructed for its designed purpose.
The battery will last over one year and is easily self replaced or by a battery kiosk or watchmaker.
The pedometer is not waterproof, however we understand accidents can occur and pedometer
damage may result. As a fair dinkum Aussie Company we offer to replace your pedometer
at 50% of the purchase price should you accidentally damage it. Simply send your damaged
pedometer with a covering note and 50% of the purchase price plus $10.00 postage and
handling fee to:
Aussie Fit Sport Science
3 Vantage Point Drive
Burleigh Heads Qld 4220
Australia
Ph/Fax [phone]
Email [email protected]
www.aussiefitsport.com.au
Please note this warranty offer is only available directly through Aussie Fit Sport Science Pty Ltd