AUTOCUE SSP17 Instruction Manual

SSP17
Guide
Camera Fixing
16. Fix the camera in
place using the camera
screws provided.
1/4” BSW
17. Connect the power
supply and the VGA or
video cable.
Power Supply
autocue.com
12. For smaller cameras the camera plate will need
to be raised. Remove the four thumb screws and then
lift off the plate.
13. Install four camera plate pillars
of the appropriate height.
14 Re-fix the camera
plate using the four
screws provided.
15. To achieve the maximum
height, combine the long and
short pillars.
Pillar combinations
3/8” BSW
11. For larger cameras the mounting plate may need
extending. Loosen the four thumb screws on the
camera plate and remove the rear two, the plate will
now slide out. Replace the two rear screws and
tighten them to secure the plate.

Assembly
1. Fix the hot shoe from your
tripod to the underside of the
mounting plate. Slide the hot
shoe to the approximate
position and tighten the
screws.
Components
A Hood and
Glass
B Monitor
C Mounting
Plate
D
Hood
Adjustment
D
C
A
B
2. Mount the unit on the
tripod.
Mounting the Camera
10. It is important that the camera lens is in the centre
of the aperture at the rear of the hood.
This is achieved by raising and lowering the camera
mounting plate and hood.
Glass Installation
3. Remove the three
thumb screws that secure
the hood frame and
open the hood.
4. Place the glass in the
hood and ensure that
the glass is located in
the recess.
5. The glass is installed with
the blue dot facing up. A
double image will be seen
in the reflection if the glass
is not installed correctly.
6. Close the hood and
replace the three thumb
screws and secure.
Please ensure that the
glass is in the recess or the
glass may be damaged.
7. The glass is now
Installed.
9. The Hood is
now locked in
the upright
position.
8. Raise the hood and lock it
in the upright position by
tightening the four thumb
screws.