AutoDab FM Operation manual

What’s in the pack?
Remote Key:
1 - Menu 4 - Station Left 7 - Pre-set Down
2 - Add/Delete 5 - OK 8 - Scan
3 - Pre-set Up 6 - Station Right 9 - On/Off
INSTALLATION
& USER GUIDE
Getting Started - Initial Setup of Head Unit
• On rst install, the AutoDAB controller will default to transmitting on 87.5MHz. Tune the car radio to this frequency.
• The car radio will display ‘AutoDAB’ and the audio message ‘Scanning AutoDAB, please wait’ will be heard.
• The audio message repeats every 5 seconds.
• Choose a preset on the car radio and store the AutoDAB frequency to it.

Pairing a Remote
• To pair remote press ‘Menu’ and ‘On/Off’ together for two seconds. A short beep will be heard conrming
your device has been paired.
• Next press ‘Menu’ to start the digital radio. After a short delay the car radio will display the rst available
digital radio station found e.g. Absolute
Browsing through Pre-set Stations
• Your AutoDAB will come with pre-sets already loaded. To browse through your pre-sets, simply use the ‘Pre-set Up / Down’
Scanning for Stations
• To update the available station in your current location, press ‘Scan’ and the audio message ‘Scanning will repeat twice.
• After around 30 seconds, the car radio will display the total number of DAB stations found.
Navigating the Station List (Alphabetical)
• Press ‘Station Left/Right’ to move up or down the station list from the current tuned station.
• Tip - If you are looking for a specic station, then go to the pre-set nearest to it in the alphabet and
move up and down from there.
Adding/Deleting Pre-sets
• When you locate a station that you want to add or delete from your pre-sets, simply press ‘Add/Del’.
• If the pre-set is not already in your pre-set list, then the station will be added, and the voice conrmation
‘Pre-set Added’ will be heard.
• If the pre-set is already included within your list, then it will delete the pre-set and the voice conrmation
‘Pre-set Deleted’ will be heard.

Menu Tree
Set Browse
Set Frequency
Set Voice Volume
Announcement
Factory Reset
AutoDAB can be navigated in either List mode (all available stations listed
alphabetically A to Z or in Ensemble mode (all stations listed by ensemble i.e.
a group of stations that are transmitted together).
Allows user to adjust the FM freq. which the AutoDAB broadcasts on. The
default is 87.5MHz.
The voice prompt can be increased by pressing ‘Pre-set Up’ and decreased
by pressing ‘Pre-set Down’. The voice volume level is displayed as a gure
between 01 to 10 max.
You can select to receive either all announcements when broadcast, just traf-
c and alarm, or turn them all off.
Restore the AutoDAB tuner to factory settings. All the pre-sets/stations will be
deleted and the AutoDAB will be reset to its original conguration.

How to t - PLUG
• Remove all the contents from the AutoDAB box
• Position the antenna in the top right of the front windscreen (top left for right
hand drive cars). The antenna should be located parallel to the A-pillar of
the car (FIG 1). We recommend that it is held in position with a temporary x
until you conrm that you have a good reception.
• Plug the cigarette lighter charger into the nearest 12v supply to where you
want to locate the AutoDAB box – the red light should illuminate.
• Plug the 3.5mm Jack into the cars aux-in socket. (if required)
• Now plug all connections into the AutoDAB box (FIG 2)
FIG 1
FIG 2