Ava Bullet Series Installation instructions manual

Mounting guide

Bullet • Mounting guide | 2
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Important warnings and safety instructions
Avoid exposing the camera to shocks, high pressure or temperatures above 50oC.
Avoid placing the camera near fans, ventilation or other noise sources. This will degrade audio performance.
Avoid scratching or leaving ingerprints on the lens cover, this degrades image quality. If possible, keep the protective
plastic on the lens cover during installation.
Do not clean the camera with harsh detergents, gasoline or chemicals such as acetone.
Do not try to repair the unit yourself. Refer all servicing of the camera to Ava or contact a reseller.
Do not install the camera during rain, mist or other conditions of high humidity. Water may be trapped inside, causing
damage or condensation issues.
This product should be supplied by a Power over Ethernet Power Sourcing Equipment (PSE) compliant to IEEE 802.3at Type 2 (PoE+).
The camera should be connected only to PoE networks without routing to the outside plant. The PoE PSE must be properly
grounded.

Bullet • Mounting guide | 3
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Box contents

Bullet • Mounting guide | 4
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Using the wall bracket
Screws are not included. The installer must use suitable fasteners.
12A 2B

Bullet • Mounting guide | 5
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Opening the housing and removing cable gland
It’s easier to access the screws when the ball joint is moved to an angle.
3 4

Bullet • Mounting guide | 6
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Installing the camera on to the wall bracket
5 6

Bullet • Mounting guide | 7
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Installing cable gland and connecting ethernet cable
7
9
8
10 11

Bullet • Mounting guide | 8
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Connect the camera and adjust the picture
Add the Camera to Ava Aware and ensure that
the video stream is working.
12
Close the camera and tighten the two screws
on the rear cover.
13
When the correct position is obtained, irmly tighten the screws (3Nm) to lock the position.
14

Bullet • Mounting guide | 9
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Change lens orientation, horizontal (16:9) - vertical (9:16)
Please be aware of the screw, it can easily be lost during disassembly

Bullet • Mounting guide | 10
Copyright © 2023, Ava Video Security. All rights reserved.AVA-BULLET-MG-06
Change lens orientation, horizontal (16:9) - vertical (9:16)
Ensure the camera body has been opened before attempting to rotate the lens
HORIZONTAL
VERTICAL