Ava Flex Installation instructions manual

Mounting guide

Ava Flex • Mounting guide | 2/7
Important warnings and safety instructions
Avoid exposing the camera to shocks, high pressure or temperatures above 40oC.
Avoid placing the camera near fans, ventilation or other noise sources. This will degrade audio performance.
Avoid placing the camera near fans, ventilation, or other heat sources. This will degrade sensor performance.
Avoid scratching or leaving ingerprints on the lens, this degrades image quality. If possible, keep the protective plastic on
the lens cover during installation.
Do not clean the camera with harsh detergents, gasoline or chemicals such as Acetone.
Do not try to repair the unit yourself. Refer all servicing of the camera to Ava or contact a reseller.
Prolonged use of the white LEDs may aect sensor readings.
This product should be supplied by a Power over Ethernet (PoE) Power Sourcing Equipment (PSE) compliant with IEEE 802.3af
or USB-C power source rated 5V 1.5A. The power supply should be UL-listed and marked “Limited Power Source”or “LPS”.
The camera and the PoE PSE must be installed within the same building, as described by Environment A of the IEEE 802.3af
standard. The PoE PSE must be properly grounded.

Ava Flex • Mounting guide | 3/7
Screw dimensions
dh= 9.4 mm
l = 32 mm
d= 4 mm
Anchor dimensions
l= 25 mm
d= Ø6mm / ¼ ”
dhdd
l
Box content
l
Required:
PH2 screw driver
Drill with 6mm (1/4”) drill bit”
Hex 2.5mm

Ava Flex • Mounting guide | 4/7
Cable routing alternatives

Ava Flex • Mounting guide | 5/7
Through the wall / ceiling cable
Installing the bracket
21 3
Dia: 6mm, [¼”]
Depth: 40mm [1.5”]
4B4A Side entry cable

Ava Flex • Mounting guide | 6/7
Attaching the camera and connecting the ethernet cable
5
76

Ava Flex • Mounting guide | 7/7
Adjusting the ball joint and video stream
8
11
Adjust the image orientation in Ava Aware.
9 10