Aveo Engineering Nubion AVE-N09PANSNL-1WA Mod(2) User manual

INSTALLATION MANUAL
Nubion
DOC.NO:AVE-N09PANSN-IM
© Aveo Engineering Group, s.r.o. All rights reserved. The information contained within this document
must not be disclosed, copied or reproduced in whole or in part without prior written permission from
Aveo Engineering Group, s.r.o.

Page 2 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Table of Contents
PART 0 MANUAL ADMINISTRATION ............................................................3
0.1. DOCUMENT APPROVAL ............................................................................3
0.2. AMENDMENT RECORD PROCEDURE ..............................................................4
0.3. AFFECTED PAGES PROCEDURE ...................................................................4
PART 1 INSTALLATION DATA........................................................................5
1.1. PRODUCT DESCRIPTION ..........................................................................5
1.2. OPERATING INSTRUCTIONS ......................................................................5
1.3. INSTALLATION SCHEMATIC /WIRING DIAGRAM ..............................................5
1.4. CONTROL &POWER INPUTS .....................................................................5
1.5. TECHNICAL SPECIFICATION ......................................................................6
1.6. TECHNICAL DRAWING.............................................................................6
1.7. WIRING CHART ....................................................................................7
1.8. OPTIC SIMULATION ...............................................................................8
1.9. EQUIPMENT LIMITATION ........................................................................ 10
1.10. CARE AND CLEANING OF LIGHTS .............................................................. 10
1.11. TESTING OF THE LIGHT BEFORE INSTALLATION ............................................. 10
1.12. NOTES ON INSTALLATION ...................................................................... 11
1.13. CONTINUED AIRWORTHINESS INFORMATION ................................................ 11
1.14. ROHS COMPLIANCE STATEMENT .............................................................. 12
1.15. EU REACH REGULATION (EC) NO.1907/2006 ......................................... 12

Page 3 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Part 0 Manual Administration
0.1. Document approval
This document has been established in accordance with an alternative procedure
to DOA approved under EASA AP429.
This installation manual is applicable for part numbers:
• Nubion Landing (12°) AVE-N09PANSNL-1WA Mod(2)
• Nubion Landing (24°) AVE-N09PANSNL-2WA Mod(2)
• Nubion Taxi (38°) AVE-N09PANSNT-3WA Mod(2)
• Nubion Taxi (55°) AVE-N09PANSNT-5WA Mod(2)
• Nubion Taxi (15° x 47°) AVE-N09PANSNT-EWA Mod(2)
Compiled by: 09. – Sep. - 2022
Petr Jaroš
Engineer, Aveo Engineering Group, s.r.o.
Approved by: 09. – Sep. - 2022
Georg Hartl
Head of DO, Aveo Engineering Group, s.r.o.

Page 4 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
0.2. Amendment Record Procedure
The master copy of this document shall be kept electronically as a read only
document under the control of Aveo Engineering Group, s.r.o. as Master Copy.
ALL amendments to this manual will initiate a raise of issue.
The original issue will be identified by “01”, and subsequent issues will be
numbered sequentially from 02 to 99 in Table 01 - Issue No. column.
ALL issues of this document will be approved by Head of DO.
0.3. Affected Pages Procedure
ALL pages affected by ANY raise of issue of this document will be listed in Table
01 - Affected Pages Column.
The reason(s) for EACH raise of issue and the description of respective change
will be provided in Table 01 - Details Column.
Changes from the previous issue are shown as follows:
a) new text is highlighted with yellow shading: new
b) deleted text is shown with yellow shading and a
strike through: deleted
Issue
No.
Details
Date
Effected
Pages
01
Initial Issue
15.Dec.2016
ALL
02
Part Numbers update
Technical specification update
Optic simulation update
21.Apr.2020
3, 5
6
7, 8, 9
03
Part Numbers update
Distribution list removal
Wiring specification update
Weight update
Electronic specification update
Section 1.14 ROHS addition
Section 1.15 EU REACH addition
09.Sep.2022
3, 5
4
5
6
6
12
12
Table 01: Document Amendment Record Table

Page 5 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Part 1 Installation data
1.1. Product Description
The Nubion™ landing or taxi light is a high powered LED light use in GA and
transport category aircraft. It has been designed to be lightweight and with a low
power draw to meet the highest requirements of all certified aircraft.
•Nubion TAXI (38°) PN : AVE-N09PANSNT-3WA Mod(2)
•Nubion TAXI (55°) PN : AVE-N09PANSNT-5WA Mod(2)
•Nubion TAXI (15° x 47°) PN : AVE-N09PANSNT-EWA Mod(2)
• Nubion LANDING (12°) PN : AVE-N09PANSNL-1WA Mod(2)
• Nubion LANDING (24°) PN : AVE-N09PANSNL-2WA Mod(2)
1.2. Operating Instructions
When installed on the aircraft, using the aircraft’s power (28 volts), the light will
be at its maximum intensity. Operating Voltage range is 18-36VDC.
1.3. Installation Schematic / Wiring Diagram
1.4. Control & Power Inputs
BLACK Negative common power supply line (ground), AWG 22
RED Positive power supply line, AWG 22
GREEN/YELLOW Chassis wire (Airplane airframe connection), AWG 22
Length: 640mm (25.2”)

Page 6 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
1.5. Technical Specification
Electronic specification - Ambient temperature (25°C):
Operating voltage: 18-36V DC
Primary input voltage: 28V DC
Voltage protection: a. Over-voltage protection: 80V (1s)
b. Over-voltage lockout: 38.5V DC
c. Under-Voltage protection
Reverse polarity protection: Yes
LED quantity: 6 pcs
Performance:
Input current: 0.75A@28V (+/- 5%)
Input power: 21W@28V (typ)
Operating temperature: -55°C to +85°C / -67°F to +185°F
Over-Temperature protection: Yes
Weight: 6.77oz (192g)
1.6. Technical Drawing
*dimensions in mm [inches]

Page 7 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
1.7. Wiring Chart
Use diagram below defining the wiring size depending on the current and the wire
length. Make sure you add up the current for all connected lights. If current is not
given, then divide the power by the voltage.

Page 8 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
1.8. Optic Simulation
Nubion LANDING (12°) PN: AVE-N09PANSNL-1WA Mod(2)
37431 Cd
Nubion LANDING (24°) PN: AVE-N09PANSNL-2WA Mod(2)
12081 Cd

Page 9 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Nubion TAXI (38°) PN: AVE-N09PANSNT-3WA Mod(2)
5977 Cd
Nubion TAXI (55°) PN: AVE-N09PANSNT-5WA Mod(2)
3132 Cd

Page 10 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Nubion TAXI (15° x 47°) PN: AVE-N09PANSNT-EWA Mod(2)
10300 Cd
1.9. Equipment Limitation
Nubion™ should only be powered by 18-36VDC.
1.10. Care and Cleaning of Lights
When you receive your Aveo Engineering Aviation Lights, they will have been
factory polished and ready to install on the aircraft.
If the lights require a deeper cleaning, they should be polished with a quality lamb’s
wool sheet and can also be used for deeper polishing. Under no circumstances
should any petroleum based product be used to clean the lights.
1.11. Testing of the Light before Installation
All Aveo Aviation lights undergo rigorous testing prior to being released from
our engineering manufacturing department. This testing involves a burn-in time
as well as other function testing. No light is released for sale without undergoing
this extensive operational testing.
When you receive the Nubion™ light, and wish to test the function of the
light prior to installation on your aircraft, please note the following:
1. Please review the written information that is enclosed in the packaging.

Page 11 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
Warranty information as well as a cautionary note about power supply
removal is enclosed with each package.
2. Remove the light from the package. Note that there are three (3) wires:
Black – Negative lead
Red – Positive lead
Green/Yellow – Chassis
3. Testing of the function of the light can be done with a regular 28V/5A dc
power supply (not a battery charger). Connect the black wire to the
ground (negative) leads of a power supply, and then connect the red wire
to the positive (+) leads on the power supply. The Nubion light should
start lighting. When installed on the aircraft, using the aircraft’s power
(28 volts), the light will be at its maximum intensity.
After testing, the light can be installed on the aircraft.
IMPORTANT NOTES:
Under no circumstances should any power supply other than a 18-36 VDC, or a
28 Volt battery be used to test the light. Do not use: Battery chargers, battery
back-up power devices, or other bench avionics testing methods to test the
aviation light. The light is functional between18 and 36 volts. Use of a battery
charger or other power unit to test the light will void the warranty and may
damage the light.
Make sure you cover your eyes while installing and testing our lights.
If you have any questions about the installation of the lights, please refer to
our web site: www.aveoengineering.com
1.12. Notes on Installation
Spread the tightening forces evenly around the mounting hole. Stainless steel
screw is recommended. Length depends upon placement location on aircraft.
1.13. Continued Airworthiness Information
Circuit/Wiring Protection
Each Nubion series light features a Negative Temperature Coefficient (NTC)
circuit that limits internal temperatures by attenuating operating current (with a
corresponding reduction of brightness) when internal temperatures reach a certain
threshold. This proprietary circuitry serves to protect the light itself, and
associated aircraft wiring, against a thermal runaway condition.
Periodic Inspection Procedure for Nubion Series
The Nubion™ lights should always be checked for proper operation during
preflight. This procedural information is already provided in all general aviation
aircraft flight manuals.
The lights should be visually inspected for general condition, proper operation, and
correct installation at each annual and/or 100 hours inspection. In addition refer
to section 1.10 of installation manual for detailed cleaning instructions.

Page 12 of 12
NubionTM
AVE-N09PANSN-IM
Issue 03
INSTALLATION MANUAL
1.14. RoHS Compliance Statement
Scope
This statement clarifies Aveo Engineering’s compliance with European Union
Directive 2015/863/EU on the restriction of the use of certain hazardous substances
in electrical and electronic equipment ("RoHS") that took effect on June 4, 2015.
The RoHS Directive restricts the sale of electronic equipment containing certain
hazardous substances in the European Union including:
Cadmium(Cd): 0.01%
Mercury: 0.1%
Lead(Pb) : 0.1%
Hexavalent chromium (Cr6+) : 0.1%
Polybrominated biphenyls (PBB): 0.1 %;
Polybrominated diphenyl ethers (PBDE): 0.1 %
Bis(2-Ethylhexyl) phthalate (DEHP): 0.1% (added in 2015);
Benzyl butyl phthalate (BBP): 0.1% (added in 2015);
Dibutyl phthalate (DBP): 0.1% (added in 2015);
Diisobutyl phthalate (DIBP): 0.1% (added in 2015)
Compliance
Aveo Engineering certifies that all products sourced from manufacturing facilities
comply with the environmental standards set forth by the Directive 2015/863/EU,
recast amendment of RoHS Directive 2011/65/EU Article (4), and do not contain
any of the above-mentioned, 10 hazardous substances above the specified limits.
All products manufactured by Aveo Engineering are RoHS-compliant. With regards
to RoHS-2 CE marking, product packaging is labeled attesting conformity if
required.
References
Directive 2015/863/EU of the European Parliament and of the Council on the
restriction of the use of certain hazardous substances in electrical and electronic
equipment.
1.15. EU REACH Regulation (EC) No. 1907/2006
Aveo Engineering declares that no chemicals are produced and that none of the
chemicals used during the production process or needed for the product
maintenance or service, is listed on the current European Chemicals Agency’s
Candidate list of Substances of Very High Concern for Authorization.