Aztech WIPC302 User manual

F R E Q U E N T L Y A S K E D Q U E S T I O N
v
1 . 0
S i n g a p o r e
A Z T E C H T E C H N O L O I E S P T E L T D
Aztech
Aztech Aztech
Aztech WIPC302
WIPC302 WIPC302
WIPC302
Wireless N IP Camera
How to set
How to setHow to set
How to set Port Forwarding on Dlink
Port Forwarding on Dlink Port Forwarding on Dlink
Port Forwarding on Dlink DCM
DCMDCM
DCM 604
604604
604?
??
?
1. Connect your Aztech WIPC302 into your Modem/Router's Ethernet LAN port with an Ethernet cable.
Make sure that your Modem/Router's Internet connection is UP, to allow you to access your IP
camera via the Internet.
2. Connect the Power adapter to your Aztech WIPC302 and plug it into the power out then switch it ON.
3. Connect your computer to the same router wherein your Aztech WIPC302 is connected.
Ensure that the DDNS information was set properly on the IP camera if you are using a Third
Party DDNS else use the Manufacturer’s DDNS.
4. Launch the Internet browser on your computer and input 192.168.0.1 then type admin
admin admin
admin for the
username and password
passwordpassword
password for the password*. This will launch your Router’s WEB User Interface.
* Note that the login information is based on the default setting of the router.

Page
2
of
2
F R E Q U E N T L Y A S K E D Q U E S T I O N v 1 . 0
S i n g a p o r e
A Z T E C H T E C H N O L O I E S P T E
L T D
5. Click Advanced then select Forwarding.
6. Input the Aztech WIPC302 IP address on the required field then input the port number on the Port
Start and End.
7. You may use the WIPC302 Utility to confirm the IP camera’s IP address and Port number. Click Apply
on your Dlink DCM604 for the settings to take effect.
WIPC302 IP address
WIPC302 IP Port Number