Aztech VC2000 Instructions for use

Easy Start Guide
Preparing your VC2000 for first use:
Kindly follow the steps provided below in setting up your VC2000 for first use.
Using a screwdriver, unfasten the
screws of the VC2000’s base plate.
1
3
Connect the power adapter to the
Docking station and plug the power
adapter to a power outlet.
4
Insert the VC2000’s battery correctly.
Using a screwdriver, fasten the
screws of the base plate again to
hold the battery in place.
2
Connect the VC2000 to the Docking
station.
Pairing your VC2000 with its Remote Control
WARNING: Ensure that the VC2000’s power switch is OFF before proceeding.
To maximize the usage of the VC2000,
allow the VC2000 to charge for 8
hours.
Press and Hold the CHARGE button
of the VC2000’s Remote control.
1
Turn ON the Power Switch of the
VC2000.
A series of beeps would occur
indicating a successful pairing
between the two devices.
2
VC2000
12

Easy Start Guide
Setting the Current Time
Turn ON the power switch, and press the
CHARGE button to enter the current time
setting.
1
1
Press and hold the SCHEDULE button until
the second figure of the time display flashes.
Press the CHARGE button to select the correct
hour.
2
Press the VC2000’s SCHEDULE button to
select the correct Day, then press CHARGE
button twice to confirm.
The Day Light LED would turn ON, indicating a
successful setup.
2
Press and hold the SCHEDULE button until the
time display’s first figure flashes then press
the CHARGE button to select the correct hour.
To Start Cleaning
Turn ON the power switch of your
VC2000.
1
On your VC2000, press the CLEAN
button.
The VC2000 will enter auto cleaning
mode and will automatically return to
docking station to recharge if needed.
2
VC2000
Setting the “DAY”
Setting the “Minute” and “Hour”
Repeat steps 1 and 2 for the minute settings.
3
4Press the CLEAN button to save the setting.
NOTE: Remember to press
the CLEAN button to save the
changes.