Aztech VC3000 Instructions for use

Please retain this easY start GUiDe for fUtUre Use.
VC3000
Smart Robotic Vacuum Cleaner
EASY START GUIDE
REMINDERS FOR FIRST USE
Before using, check if the power voltage of your Aztech VC3000 corresponds
correctly to your home’s power supply.
Position the Aztech VC3000 on a smooth, heat resistant, and stable ground.
Ensure to correctly insert the required batteries of the Aztech VC3000, its
virtual wall (2 AA) and remote control (2 AAA), while observing the correct
polarity of the batteries to be inserted.
In using the remote control, ensure that you are at least 4 meters away from
the vacuum cleaner and that the remote control is properly aimed at the
vacuum cleaner’s sensor.
Ensure that there are no obstacles and/or uneven surfaces 2 meters in front
and 0.5 meters on both sides of the Docking Station.
The Virtual Wall will allow you to limit the cleaning areas of your Aztech
VC3000. Always ensure that its front and sides are free from any kind of
blockage and/or obstructions that may hinder its functionality.
Should damages be found in the appliance, do not use the appliance and
immediately bring it to the Aztech Service Center.
1.
2.
3.
4.
5.
6.
7.
PACKAGE CONTENTS
VC3000 Docking Station Power Adapter Virtual Wall
Trailing Bar Cleaning Brush (2) Side Brush
Suction InletHEPA Filter (2) Mops
Remote Control

Please retain this easY start GUiDe for fUtUre Use.
4 - STEP AUTOMATIC CLEANING
Position the docking station on a smooth and
stable ground and connect the Docking
Station’s power adapter to its DC jack and
plug it to a power outlet.
STEP 1
NOTE : Ensure to keep both of the docking
station’s front (2 meters) and sides (0.5meters)
free from obstacles and/or blockages.
STEP 2
Switch ON the Aztech VC3000 and lodge it
into the Docking Station to begin charging
the Aztech VC3000.
NOTE: For rst use/reuse (after a long period
of rest), charge the Aztech VC3000’s battery
for at least 16 hours.
CONTROL
PANEL
REMOTE
CONTROL STEP 4
On the Aztech VC3000’s control panel or
on its remote control, press the AUTO button
to begin automatic cleaning. The Aztech
VC3000 would automatically return to its
docking station to charge itself once it runs
out of batteries.
**OBSERVE BATTERY POLARITY
STEP 3
Correctly insert the needed batteries of the
remote control (2 x AAA) and the Virtual
Wall (2 x AA) and position the Virtual Wall
on the preferred location where you want
to limit the Aztech VC3000’s movement.