BaByliss PRO Titanium Foil Shaver User manual

TITANIUM FOIL SHAVER
BABFS2U

TITANIUM FOIL SHAVER
A heavy-duty dual foil shaver designed for precision fading and
blending. With ultra-ne, hypoallergenic titanium foils for a close cut
nish and high power cord/cordless motor to guarantee sustained
performance for the ultimate nishing tool.
• High power cord or cordless performance
• Hypoallergenic titanium foils for close cut performance
• 3 hour charge time for 180 mins use
• All metal housing design
• Charging indicator
• 3m power cord
• Cleaning brush
• Storage pouch
• Includes replacement foils
SAFETY CAUTIONS
•Original instructions. Read these safety precautions
carefully before using the unit! This appliance should
only be used as described within this instruction
booklet. Please retain for future reference.
IMPORTANT CHILD SAFETY
• ALWAYS keep out of the reach of very young children
(during and after use).
• This appliance should not be used, cleaned or
maintained by children.
• Always take extra care if used on children or near
children.
• Do not use on very young children.
IMPORTANT SAFETY
• WARNING! Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
• Do not immerse the appliance in water or other liquids.
• Keep the appliance dry.
• UK Only: Do not use this appliance in the bathroom.
• Outside the UK: If using the appliance in a bathroom,
unplug after use as the proximity of water can be
dangerous even if the appliance is switched off. For
additional protection the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
• The appliance’s charging stand and/or adaptor must
be kept away from sources of water so that they do not
fall into the water.
• CAUTION! Keep the power cord and the appliance
dry. For appliances with a removable power supply
unit, remove the power cord before cleaning.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the

appliance has been dropped. In the event of damage
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information).
• Do not use the appliance if the charging adaptor or lead
is damaged. In the event of damage, discontinue use
immediately. If the charging adaptor or lead is damaged,
it must be replaced by the manufacturer. Return the
appliance to the Customer Care Centre (refer to ‘UK
After Sales Service’ section for further information). No
repair must be attempted by the consumer.
• Only use the attachments supplied with this appliance.
• WARNING! For the purposes of recharging the battery,
only use the detachable charging supply unit provided
with this appliance – CA78M. This symbol
indicates there is a detachable power supply for means
of charging.
• Do not leave the appliance unattended when switched
on.
• Do not leave the appliance plugged in for more than
24 hours.
• Unplug immediately if any problems occur during use.
• Do not place the appliance on any surface whilst in
operation.
• Special care is required when using the appliance close
to the ears, eyes and face.
• This appliance may be used by children aged from 8
and older and people with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction on the
safe use of the appliance and understand the hazards
involved. Children must not play with the appliance.
• This product contains a Ni-Mh rechargeable battery that
is not to be removed from the appliance for charging.
The batteries in this appliance are non-replaceable.
Batteries must be disposed of safely at the end of life.
Please take to a recycling centre for safe disposal. If
the battery leaks, avoid touching it and dispose of it at
a recycling centre.
• The supply terminals are not to be short circuited.
• This product complies fully with all appropriate EU
and UK Legislation and the standards relevant to this
type and class of appliance. We are an ISO9001:2015
certied company that continually evaluates our
Quality Management System performance. If you have
any queries regarding product safety and compliance,
please contact the Conair Customer Care Line (refer
to ‘UK After Sales Service’ section).
WEEE - END-OF-LIFE ELECTRICAL AND ELECTRONIC
EQUIPMENTS
In everybody’s interest and to actively participate in
protecting the environment and human health:
• Do not discard your products with your unsorted
household wastes.
• The WEEE (Waste electrical and electronic equipment)
must be collected separately.
• Use the return and collection systems dedicated to the

WEEE available in your area. In this way, some materials
can be recycled, re-used or recovered.
• By ensuring this product is disposed of properly, you will
help prevent potential negative consequences for the
environment and human health due to possible content
of hazardous substances.
For more detailed information about the disposal of this
product, please contact your local household waste
disposal service.
PREPARATION FOR USE
General
• Always inspect the appliance before use to ensure the foils are free
from hair, debris etc.
• Always ensure hair is clean and dry before shaving.
INSTRUCTIONS FOR USE
Charging the Appliance
• Before using the appliance for the rst time, charge the battery
continuously for 3 hours. Maximum battery capacity will only be
reached after 3 completed charging and discharging cycles.
• Plug the charging adapter into a suitable mains power socket
and switch on. The blue LED indicator light will ash when correctly
connected to the mains power and will continuously ash until the
battery has fully charged. When the battery is fully charged the LED
indicator light will stop ashing but remain on.
NOTE: Before charging, ensure the shaver switch is in the (0) OFF
position.
• When the shaver is running low on charge, the LED indicator light
will ash, warning there is approximately 3 minutes of battery use
remaining. A 3 hour charge will provide approximately 180 minutes
use. A 30 minute quick charge will provide approximately 30 minutes
use.
• If the charging light starts to ash rapidly (more than 4 ashes per
second) then the appliance is faulty. If this happens then please stop
charging and remove the adapter from the mains and contact the
Conair Customer Care Line. (See ‘UK After Sales Service’ section for
further information).
Preserving the Batteries
• In order to maintain the optimum capacity of the rechargeable
batteries, the appliance should be recharged for 3 hours
approximately every 3 months.
• Using the shaver on the mains - ensure that the shaver is switched
off. Plug into a suitable mains socket. Wait for approximately a
minute, and then switch on.
IMPORTANT: Do not use the shaver in this mode for more than 20
minutes.
Oiling Instructions
• For optimum cutting performance, it is highly recommended
to oil the cutting blades after every use.
• When using the oil for the rst time, unscrew the cap and
cut off the very end of the plastic tube with a pair of scissors.
• Remove the foils and switch the appliance on.
• Holding the shaver at a 45 degree angle, gently squeeze
the oil tube and apply 1 drop directly onto the cutter blades.
• Leave the unit on for a further few seconds to allow the oil to
thoroughly spread along the length of the blades.
• Switch off the unit and remove any excess oil by gently dabbing with
a cloth before using on hair.
• Replace the foils over the cutting blade.

Shaving
• The shaver is designed for a close cut on hair shorter than 1/32".
If hair is longer, use a trimmer to shorten the hair prior to using the
shaver.
• Remove the protective cover and turn the shaver on using the switch
on the side of the unit.
• Hold at a right angle and move the shaver slowly and smoothly
against the grain of your beard.
• Short, circular strokes will help to make the hairs stand out and make
shaving easier.
• The foils should glide over the skin. Ensure not to apply too much
pressure or this may cause damage to the foils.
• Turn the unit off using the switch on the side of the unit.
• Thoroughly clean the hair from the foils and the cutting blade to
ensure shaving comfort during next use.
CLEANING & MAINTENANCE
• To maintain optimum performance, the appliance should be cleaned
after each use.
• Never press on the cutting blades or the shaving foil as this can
cause irreparable damage.
• Blow any remaining hair from the foils and cutting blades or use the
cleaning brush provided.
• Ensure that no water gets inside the unit to avoid damaging
the shaver.
• When cleaning, do not apply any detergents and do not use any
abrasive or sharp objects. They can cause irreparable damage to the
shaver.
• To clean the external surface of the shaver, use a damp cloth. Do
not use strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel.
REMOVE & REPLACE THE FOIL HEAD ASSEMBLY
• Remove the foil head assembly by pressing the round release button
located on the side of the shaver. Hold the foil head assembly on
both sides and lightly pull away from shaver unit.
• Align the replacement foil head assembly over the cutters. Carefully
move the replacement foil head assembly down towards the shaver
unit until it firmly snaps into place.
CAUTION! Be careful not to damage the foils or cutter blades whilst
installing.
REMOVE & REPLACE THE CUTTER BLADES
• To remove cutters, place your fingers on each side and gently pull up
and away from the drive shaft.
• To replace cutters, align cutter above the drive shaft and lightly push
down until it snaps into place.
• Replace the foil head assembly, turn shaver on to ensure it is
working properly.
TECHNICAL DATA
Vibration and noise levels
Adaptor CA78M
Vibrations < 2.5 m/s²
LpA (dB(A)) < 70
UK GUARANTEE
This BaByliss PRO appliance is guaranteed for professional use for 2
years and is only valid within the United Kingdom.
Exclusions
This guarantee will no longer be valid meaning that The Conair Group
Ltd will not be liable to repair or replace your product where:
1.) The appliance has been used on a voltage supply other than that
which is marked on the product, or advised within this instruction
booklet.
2.) The appliance has been purchased from an unauthorised stockist*.
3.) Repairs or alterations have been attempted by unauthorised
persons.

4.) The failure of the appliance is a direct result of misuse.
5.) The failure is a result of not following the instructions for use.
This guarantee does not cover any cosmetic damage due to misuse
of the product nor any damage to persons or property that occurs
because of product misuse.
This guarantee does not include consumable items such as blades,
foils and cutter heads which are available as spares from our BaByliss
PRO website; https://babyliss-pro.conairspares4u.co.uk/
*unauthorised stockists include, but are not limited to online auction
sites, private sellers and those selling second hand goods, refurbished
products etc.
Please contact the Conair Customer Care Line on 03705 133 191
(09:00 to 17:00 Monday to Friday) or e-mail [e-mail] for
further information on authorised stockists.
It is important to retain your proof of purchase. We recommend
attaching your receipt to this page.
Even where a refund may be applicable, no refund will be provided
without a valid receipt or proof of purchase, we will only be able
to offer a repair or replacement service. Please note this does
not apply if the product was purchased directly from The Conair
Group Ltd.
Guarantees on replacement products run from the original purchase
date or date of delivery, whichever is later, and not from the date of
replacement.
This guarantee is an additional benefit and does not affect your
statutory rights as a consumer.
If you have any queries regarding this guarantee please contact the
Conair Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday
to Friday) or e-mail [e-mail].
UK AFTER SALES SERVICE
For further advice on using the appliance or should you need to return
your product, please contact the Conair Customer Care Line on
03705 133 191 (09:00 to 17:00 Monday to Friday) or e-mail your enquiry to
[e-mail].
Return address:
Customer Care Centre
Conair Logistics
Unit 4, Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your returns number, name and address details, together
with a copy of proof of purchase and details of the fault.
Please note this Instruction Booklet is not the guarantee.
SAFE DISPOSAL
The symbol on the product or on its packaging indicates that this
product may not be treated as household waste. Instead it should be
handed to an appropriate collection point for the recycling of Electrical
and Electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product. For more detailed
information about the recycling of this product, please contact your
local council ofce or your household waste disposal service.

IB-19/101C