Backyard Creations OFW107S-M User manual

1
SIENNA 34" SLATE TOP FIRE PIT
MODEL #OFW107S-M
Questions, problems, missing parts? Before returning to your retailer,
call our customer service department at 1-877-447-4768,
8:30 a.m.-4:30 p.m., CST, Monday-Friday or email us at
[email protected].
30-10-061 Rev 9/29/14

2
PACKAGE CONTENTS
PART DESCRIPTION QUANTITY
A Handle 1
B Mesh Cover 1
C Wood Grate 1
D Fire Bowl 1
E Ash Catcher 1
F Slate Top 1
G Legs 4
H Side Panels 4
I Poker 1
H
E
I
F
C
B
A
G
D

3
HARDWARE LIST
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNINGS:
• FOR OUTDOOR USE ONLY! Burning wood orcharcoal indoors can kill you. It gives off carbon
monoxide, which has no odor.
• NEVER LEAVE FIRE UNATTENDED!
• DO NOT allow children or pets near the re pit without supervision.
• NEVER place a cover on re pit when in use. Ensure the re pit and mesh cover have cooled before
placing a cover over the re pit.
• NEVER burn in vehicles, tents or indoors. CARBON MONOXIDE HAZARD.
• When the re pit is in use, the handle on the mesh cover can reach extreme temperatures that
can cause serious injury to an unprotected hand. Use a poker when handling.
• DO NOT touch surface of re pit while in use.
CAUTIONS:
• Burn only wood, charcoal or re logs in the re pit.
• Always ensure that the mesh cover is secured over re bowl while in use.
• DO NOT place or use re pit under a canopy of trees.
• DO NOT use gasoline or kerosene to start the re in your re pit.
• DO NOT use this unit on a wood deck, long or dry grass and/or leaves, or on combustible surfaces.
• DO NOT attempt to move the re pit while it is hot or in use.
• Place the re pit no closer than 8 feet/ 2.4 meters from walls or combustibles during use.
• Adequate re extinguishing material should be readily available.
• Poker handle may become hot during and after use.
• Use heat-resistant gloves to handle hot tools.
CALIFORNIA PROPOSITION 65 WARNING: Fuels used in wood or charcoal burning appliances and the
products of combustion of such fuels, contain chemicals known to cause cancer, birth defects or other
reproductive harm.
Consumers should check State and Provincial, in addition to local codes and regulations regarding the
use of the product.
SAFETY INFORMATION
M5x10mm
Bolt
Qty. 3
M6x10mm
Bolt
Qty. 16
M5 Nut
Qty. 3
AA BB CC DD EE
M6 Nut
Qty. 4
M6 Flange
Nut
Qty. 1
FF
M6/M5
Wrench
Qty. 1

4
PREPARATION
ASSEMBLY INSTRUCTIONS
1. Insert handle (A) into hole in mesh cover (B).
Use wrench (CC) to secure M6 ange nut (DD) to
the underside of the mesh cover (B).
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 25 minutes
Tools Required for Assembly: Phillips Screwdriver (Not Included) and Wrench (Included)
EE
1
B
A
DD
Hardware Used
DD M6 Flange Nut x 1
Wrench
FF

5
2. Attach ash catcher (E) to re bowl (D) by
inserting three M5x10mm bolts (AA) into
predrilled holes and secure with M5 nuts (BB).
Tighten with wrench (FF) and screwdriver.
3. Attach leg (G) to slate top (F) using two M6
Nuts (EE). Repeat using remaining three legs.
Secure all hardware with wrench (FF), but do not
tighten at this time.
4. Attach Side Panels (H) to the Legs (G) using
M6x10mm Bolts (CC).
Tighten all hardware. including parts from step 3,
with screwdriver and wrench (FF).
ASSEMBLY INSTRUCTIONS
2
F
D
G
E
AA
3
H
G
4
Hardware Used
EE M6 Nut x 4
EE
Hardware Used
AA M5x10mm Bolt x 3
BB M5 Nut x 3
BB
Wrench
FF
Wrench
FF
CC
Hardware Used
CC M6x10mm Bolt x 16

6
ASSEMBLY INSTRUCTIONS
5. Turn completed base and slate top assembly
right side up. Place re bowl (D) into base
as illustrated. Place wood grate (C) into re bowl
as illustrated. Place mesh cover (B) over re
bowl as illustrated.
Keep poker (I) near re pit for use as needed.
5B
C
I
D
I

7
CARE AND MAINTENANCE
• To extend the life of your re pit, clean it after each use.
• To protect re pit nish, use a soft cloth to wipe re pit and poker.
• Do not attempt to clean while hot.
• Clean ash catcher after each use once ashes have cooled.
• Store in a cool, clean, dry place.
1-YEAR LIMITED FRAME WARRANTY
If within one year from the date of original purchase, this item fails due to a defect in material or
workmanship, we will replace or repair at our option, free of charge. To order parts or to obtain
warranty service, call 1-877-447-4786, Monday - Friday, 8:30 - 4:30 p.m. CST. This warranty does
not cover defects resulting from improper or abnormal use, misuse, accident, or alteration.
Failure to follow all instructions in the owner's manual will also void this warrranty. The
manufacturer will not be liable for incidental or consequential damages, or common erosion of
outdoor products. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This warranty gives you
specic legal rights, and you may also have other rights which vary from state to state
GHP Group Inc. 6440 W. Howard St. Niles, IL, USA 60714-3302, USA

8
REPLACEMENT PARTS LIST
For replacement parts, call our customer service department at 1-877-447-4768, 8:30 a.m. – 4:30 p.m.,
CST, Monday – Friday.
PART DESCRIPTION PART #
A Handle 40-07-453
B Mesh Cover 40-08-113
C Wood Grate 40-08-114
D Fire Bowl 30-01-008
E Ash Catcher 40-08-116
F Slate Top 30-01-009
G Legs 30-06-297
H Side Panels 30-06-002
I Poker 40-04-409
DESCRIPTION PART #
Hardware Pack 30-09-002
Printed in China
H
E
I
F
C
B
A
G
D
#30-09-002
DD
AA BB EE
CC
FF
Model/Modelo/Modéle
#OFW104SC/ #OFW104SC-1
#OFW104S/ #OFW104S-KR/
#OFW107S-M