1" high frequency compression driver. Low mass mylar
diaphragm ensures a very flat frequency response and
optimized ceramic magnet assembly allows for high
sensitivity and low distortion up to 18 kHz.
Specification 1
Throat Diameter 25 mm (1 in)
Nominal Impedance 8 Ω
Minimum Impedance 7.8 Ω
Power Handling
(2200 –20000 Hz)
Nominal230 W
Continuous Program360 W
Sensitivity (1W/1m) 107 dB
Frequency Range 1.5 – 18 kHz
Recommended Crossover52.2 kHz
Voice Coil Diameter mm (1.7 in)
Winding Material Aluminium
Inductance 0.11 mH
Diaphragm Material Mylar
Flux Density 1.5 T
Also available in 16 Ω, data upon request
Mounting and Shipping Information
Two M6 holes 180° on 76 mm (3 in) diameter
Overall Diameter 102 mm ( in)
Depth 58 mm (2.3 in)
Net Weight (1 unit) 1.6 kg (3.5 lb)
Shipping Weight (8 units) 13.9 kg (30.6 lb)
Shipping Box (8 units) 220x220x150 mm
(8.7x8.7x5.9 in)
1 Driver mounted on B&C ME 5 horn.
2 2 hours test made with continuous pink noise signal (6 dB crest factor) within
the specified range. Power calculated on rated minimum impedance.
3 Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
Applied RMS Voltage is set to 2.83V for 8 ohms and V for 16 ohms Nominal
Impedance. Average SPL from 1000 to 18000 Hz.
5 12 dB/oct. or higher slope high-pass filter.
DE 16 |Hf Compression drivers
Speakers HPL Coaxials HF Compression drivers Horns
