B&D MPC3 User manual

B&D MPC3 & MPC4 Coding Instructions
Step 1: Erasing Factory Code
1. Press and hold the top two buttons at the same time (unlock and lock) on the
remote we have supplied you. The LED light will flash 3 times. Continue holding
both buttons.
2. While still holding LOCK, release the UNLOCK button and then press it 3 times.
The LED light will flash constantly to indicate that the factory code has successfully
been deleted.
3. Release all buttons.
4. Test: press a button on the remote. If the deletion of the factory code has been
successful, the LED should not work when you press any button.
Please note: during the deletion procedure, make sure to keep the “up” button
pressed the whole time.
Step 2: Copying the Code from an Existing Operational Remote
1. Place your new remote we have supplied, and your existing operational remote
back to back
2. Press and hold one button on your new duplicator remote you wish to operate
your door. The LED should flash 3 times quickly to indicate that your duplicator
remote is in the “learn-code” mode. Do not release this button.

3. Press and hold the button that operates your door you wish to copy on your
original remote –this will send out the signal for your duplicator remote to learn.
When you see the LED light on your duplicator remote start flashing constantly –
then coding has been successful.
4. Release all the buttons, and then test your new remote to make sure that it is
working.
TIPS:
A: It is necessary to erase the code on your new remote before you start the
copying phase new remote before the copy procedure
B. Try other positions such as head to head or side by side if coding fails during
“step 2”. This sometimes happens, as the antenna on your existing remote that
transmits the remote signal does not reach far enough for your new remote to pick
it up
C. If everything fails, change the battery in both your existing and new remote, and
then repeat from step 1.
How to Restore an Accidently Erased Remote Control
Press and hold the bottom two buttons on your new remote for 5 seconds.