B&G Zeus3 Glass Helm User manual

For product manuals, technical specications,
certicates and declarations refer to the
product website:
www.bandg.com
*988-11985-001*
Zeus Glass Helm
INSTALLATION GUIDE
Technical specication
Parts included
Cable retainer
A
CJ
G
H
I
B
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
E
F
D
A. Display unit
B. Bezels
• 1 set black bezels
• 1 set silver bezels Documentation pack
C. Power cable, fuse, fuse holder and connector block
D. RJ45 to 5-pin Ethernet adapter cable
E. NMEA 0183 connector block
F. Suncover
G. Cable retainer kit
H. NMEA 2000 starter kit
I. Panel mounting kit
J. Documentation pack
16” unit 19” unit 24” unit
Display
Resolution 1920 x 1080
Brightness 1000 nits
Touch screen Full touch screen (multi-touch)
Viewing angles in degrees (typical value @
contrast ratio = 10) 80° top/bottom, 80° left/right
Electrical
Supply voltage 12/24 V DC (10 - 31.2 V DC min - max)
Power consumption - Max 40 W +- 4 W 50 W +- 4 W 80 W +- 4 W
Recommended fuse rating (12 V / 24 V) 6 A / 3 A 7 A / 4 A 10 A / 5 A
Environmental
Temperature range -15°C to +55°C (5°F to 131°F)
Storage temperature -20°C to +60°C (4°F to 140°F)
Waterproof rating IPX6 (when panel mounted correctly with only the front exposed)
Humidity IEC 60945 Damp heat 66°C (150°F) @ 95% relative (48 hr)
Shock and vibration 100 000 cycles of 20 G
Interface/Connectivity
Ethernet 3x (RJ45)
USB 3x (USB-A)
J1393 1x (Micro-C)
NMEA 2000 1x (Micro-C)
NMEA 0183 4 ports
Video output 1x high denition video output (1080p, no HDCP, HDMI-A)
Video input 2x composite video (BNC)
1x high denition video (1080p, HDCP 1.4, HDMI-A)
Data card reader 1x slot (microSD)
Wireless Internal 802.11b/g/n
Physical
Compass Safe Distance - Metric, imperial 50 cm
Weight (display only) 3.9 kg (8.6 lbs.) 4.8 kg (10.5 lbs.) 7.8 kg (17.2 lbs.)
Mounting type Panel mount or bracket (optional accessory)

VIDEO IN
+-
+-
HDMI IN HDMI OUT
1. Shield
2. Signal
Cable plug
Rear connections
Power
NMEA 0183
4 1
C DB
A
POWER
C D
E
External alarm
C DB C DB
F
G
Siren Buzzer
Power control
USB
NMEA 2000
Power
SD card
Ethernet
A. Power control (Yellow)
B. External alarm (Blue)
C. DC positive +12/24 V (Red)
D. DC negative (Black)
E. Fuse
F. Siren and relay
G. Buzzer
H. Ignition switch
I. Master/Slave bus
¼Note: For sirens that draw more than 1 Amp, use a relay.
¼Note: If a unit has its power state controlled by another
device (or ignition switch), it cannot be totally powered
down. It can however enter a standby state to save
power.
¼Note: Refer to the software setup chapter in the
installation manual for master/slave conguration.
Video
Supply voltage:
10.4 < V DC < 31.2
Power consumption:
16” unit: < 40 W +- 4 W
19” unit: < 50 W +- 4 W
24” unit: < 80 W +- 4 W
A
A
HA
A
I
A
By power key By power supply
By ignition By master/slave bus
NMEA 2000
9 < V DC < 16
3 A fuse
USB
Card
XXX X
XXX X XXX X
NETWORK 1-3
Micro C
RJ45
USB A Micro SD
card slot
HDMI A
USB A BNC
HDMI A 4 pin
connector
4-10 pin
connector(s)
J1939
J1939 1. Shield
2. Not used
3. CAN GND
4. NET-H
5. NET-L
Cable plug
¼Note: For fuse rating see technical specication.
4321 8765 109
4321 87 6
5109
n n nnn
Pin Top row Bottom row Purpose
1Port 1 Port 3 TX_B (-)
2Port 1 Port 3 TX_A (+)
3Port 1 Port 3 RX_B (-)
4Port 1 Port 3 RX_A (+)
5Port 2 Port 4 TX_B (-)
6Port 2 Port 4 TX_A (+)
7Port 2 Port 4 RX_B (-)
8Port 2 Port 4 RX_A (+)
9Port 2 Port 4 Common
10 Port 2 Port 4 Shield
n4 to 10 pin connector(s) can be used. The
pin number (n) depends on the connectors
location in the unit socket.
¼Note: Ports 2 and 4 have additional Common and
Shield connections to conform to NMEA 0183-HS.