BANGGOOD MinimumRC Spacewalker Manual

MinimumRC Spacewalker
Install Manual
All manuals and user guides at all-guides.com
all-guides.com

1.Stitching fuselage.
2.Take the fuselage partition (a total of 5), according to the installation of the tenon
position.
All manuals and user guides at all-guides.com

3.Note that the installation is as much as possible to ensure that the partition is
perpendicular to the deck.
4.Battery bracket parts.
All manuals and user guides at all-guides.com

5.Install battery bracket.
6.Battery hatch bracket parts.
All manuals and user guides at all-guides.com

7.Install battery hatch bracket.
8.Fuselage side mask.
All manuals and user guides at all-guides.com

9.Install the fuselage side of the mask in accordance with the tenon position, try to
stick glue from the internal.
10.Fuselage tail mask support part.
All manuals and user guides at all-guides.com
all-guides.com

11.Stick fuselage tail mask support part.
12.Cockpit mask.
All manuals and user guides at all-guides.com

13.Install the cockpit mask. Note that the front and rear edges of the mask should be
aligned with the edge of the spacer frame and the trailing edge does not overlap
with the tail mask support in the previous step.
14.Fuselage tail mask, can be rolled into the arc in order to install.
All manuals and user guides at all-guides.com

15.Install fuselage tail mask.
16.Head reinforcement tablets.
All manuals and user guides at all-guides.com

17.Install head reinforcement tablets.
18.Cabin reinforcement tablets.
All manuals and user guides at all-guides.com

19.Install cabin reinforcement tablets.。Note:After it is installed in place,both sides of
the fuselage side of the mask should be 1mm longer than the bottom of the part to
install the cabin mask.
20.Landing gear part.
All manuals and user guides at all-guides.com
all-guides.com

21.Overlap 3 landing gear parts in sequence.
23.Install landing gear parts.
All manuals and user guides at all-guides.com

24.Stitching cabin mask.
25.Remove the battery compartment cover.
All manuals and user guides at all-guides.com

26.Install the cabin mask in accordance with the tenon position, try to stick glue from
the internal.
27.Nose assembly.
All manuals and user guides at all-guides.com

28.Install nose assembly.
All manuals and user guides at all-guides.com

29.Polished the body.
30.Nose assembly(2mm thickness X1,1mm thickness X1).
All manuals and user guides at all-guides.com
all-guides.com

31.Overlapping adhesive nose assembly
32.Hood bottom plate
All manuals and user guides at all-guides.com

33.Install nose assembly
34.Hood bottom plate support parts.
All manuals and user guides at all-guides.com

35.Combined into the hood skeleton.
36.Engine cover mask. Can be rolled into the arc in order to install.
All manuals and user guides at all-guides.com

37.Install engine cover mask.
38.The hood is mounted on the fuselage and polished as a whole.
All manuals and user guides at all-guides.com