BANGGOOD MinimumRC Spacewalker Manual

MinimumRC Spacewalker
Install Manual

1.Stitching fuselage.
2.Take the fuselage partition (a total of 5), according to the installation of the tenon
position.

3.Note that the installation is as much as possible to ensure that the partition is
perpendicular to the deck.
4.Battery bracket parts.

5.Install battery bracket.
6.Battery hatch bracket parts.

7.Install battery hatch bracket.
8.Fuselage side mask.

9.Install the fuselage side of the mask in accordance with the tenon position, try to
stick glue from the internal.
10.Fuselage tail mask support part.

11.Stick fuselage tail mask support part.
12.Cockpit mask.

13.Install the cockpit mask. Note that the front and rear edges of the mask should be
aligned with the edge of the spacer frame and the trailing edge does not overlap
with the tail mask support in the previous step.
14.Fuselage tail mask, can be rolled into the arc in order to install.

15.Install fuselage tail mask.
16.Head reinforcement tablets.

17.Install head reinforcement tablets.
18.Cabin reinforcement tablets.

19.Install cabin reinforcement tablets.。Note:After it is installed in place,both sides of
the fuselage side of the mask should be 1mm longer than the bottom of the part to
install the cabin mask.
20.Landing gear part.

21.Overlap 3 landing gear parts in sequence.
23.Install landing gear parts.

24.Stitching cabin mask.
25.Remove the battery compartment cover.

26.Install the cabin mask in accordance with the tenon position, try to stick glue from
the internal.
27.Nose assembly.

28.Install nose assembly.

29.Polished the body.
30.Nose assembly(2mm thickness X1,1mm thickness X1).

31.Overlapping adhesive nose assembly
32.Hood bottom plate

33.Install nose assembly
34.Hood bottom plate support parts.

35.Combined into the hood skeleton.
36.Engine cover mask. Can be rolled into the arc in order to install.

37.Install engine cover mask.
38.The hood is mounted on the fuselage and polished as a whole.