Baofeng Pofung UV-5R User manual

UV-5R Manual
Page 1
pofung UV-5R
Pre conditions
1Charge Battery
2Attach antenna
3ake Note of: <MENU>, <Up Arrow>, <Down Arrow>, <EXI >,
4 Orange VFO/MR, BlueA/B, Black BAND,
5 10 Key Number Pad. Used to enter key numbers
6 Special Keys in the Right column below <EXI >
7urn radio ON, the knob ON / Off volume control
8 Set Frequency Step <MENU> 1 <MENU> select a frequency step to lowest settings
9 Choose “A” Display Blue button <A / B>
10 Enter a receive frequency 145115 NO E the 5KHz LSD

UV-5R Manual
Page 2
he receive frequency is the only thing you can enter directly without using the MENU structure. Below are the MENU choices.
Using the menu is relatively straight forward after you have used it a while: <MENU>Choice<MENU>setting<MENU>
he arrow keys allows you to set receive frequency and scrol through menu choices and setting choices
Choice Range
<MENU> Menu Choice 0 – 40
MENU Key pneumonia Definition Range Default
0 SQL Squelch Level 0 – 9 3
1 STEP Frequency Step 0 – 5 25.0K
Key Value in Khz
0 2.5K
1 1 5.0K
2 2 6.25K
3 3 10.0K
4 4 12.5K
5 5 25.0K
2 XP ransmit Power 0 – 1 1 – 4W
Key Values
0 HIGH 4W HIGH
1 LOW 1 Watt
3 SAVE Battery Save Off-4 3
4 VOX Voice Operated X Off – 10 Off
5 WN Wideband / Narrowband '0 – 1 0 – Wide
Key Values
0 WIDE 5kHz WIDE
1 NARR 2.5kHz
6 ABR Display Illumination ime Off – 5 5
7 DR Dual Watch 0 – 1 0 – Off
8 BEEP Keypad Beep 0 – 1 1 – On

UV-5R Manual
Page 3
9 O ransmission ime-out- imer 15 – 600 (seconds) 60 Seconds
10 R-DCS Receiver DCS Off, D023N - D754I Off
11 R-C CS Receiver C CSS Off, 67.0 - 254.1 Off
12 -DCS ransmitter DCS Off, D023N - D754I Off
13 T-CTCS Tr nsmitter CTCSS
Off, 67.0 - 254.1
Off
Number Frequency Number Frequency
01 67.0 02 69.3
03 71.9 04 74.4
05 77.0 06 79.7
07 82.5 08 85.4
09 88.5 10 91.5
11 94.8 12 97.4
13 100.0 14 103.5
15 107.2 16 110.9
17 114.8 18 118.8
19 123.0 20 127.3
21 131.8 22 136.5
23 141.3 24 146.2
25 151.4 26 156.7
27 159.8 28 162.2
29 165.5 30 167.9
14 VOICE Voice Prompt 0 – 1 0, ENG
15 ANI-ID Automatic Number ID 80808
16 D MFS D MF tone of transmit 0, D +ANI
Key Value Notes
0 Off
1 D -S S-CODE only
2
3 D +ANI Both
ANI code
onlyANI-S

UV-5R Manual
Page 4
17 S-CODE Signal Code 1 -15 1 Actual codes set by computer only
18 SC-REV Scanner Resume Method 0 – 2 0, O
Key Values Notes
0 O ime Operation
1 CO Carrier Operation
2 SE Search Operation
19 P -ID When to send the P -ID 0 – 3 0, Off
Key Value Notes
1 BO Beginning of transmition
2 EO End Of ransmit
3 BO H Both BO and EO
20 P -L Signal code sending delay 0 – 30 5
21 MDF-A Channel Mode A Display 0 – 2 2, FREQ
Key Values Notes
0 CH Channel number
1 NAME Channel name
2 FREQ Frequency
22 MDF-B Channel Mode B Display 0 – 2 2, FRQ
Key Value Notes
0 CH Channel number
1 NAME Channel name
2 FREQ Frequency
23 23 BCL Busy Channel Lock-out 0 – 1 1, Off
Key Value Notes
1 ON
0 OFF
24 AU OLK Automatic Keypad Lock 0 – 1 1, Off
Key Value Notes
0 OFF
1 ON

UV-5R Manual
Page 5
25 SFT-D Frequency Shift Direction 0 – 2 0, Off
Key Value Notes
0 Off
1 "+
2 “-
26 OFFSET Frequency shift mount 00.000 Mjz
Values (MHz) Notes
00.000 - 69.990
27 MEM-CH Store Memory Ch nnel 000 – 127 000
Do 28 first <MENU> 27 <MENU> Chanel <MENU> <EXI >
28 DEL-CH Delete memory ch nnel 000 – 127 000
<MENU>28<MENU>Chanel><MENU><EXI >
29 W -LED Display back-light colour, Standby 0 – 3 0, Off
Key Values Notes
0 Off
1 BLUE
2 ORANGE
3 PURPLE
30 RX-LED Display back-light colour, Receive 0 – 3 1, BLUE
Key Value Notes
0 OFF
1 BLUE
2 ORANGE
3 PURPLE
31 X-LED Display back-light colour, ransmit 0 - 3 2, ORANGE
Key Value Notes
0 OFF
1 BLUE
2 ORANGE

UV-5R Manual
Page 6
3 PURPLE
32 AL-MOD Alarm Mode 0 – 2 0, SI E
Key Value Notes
0 SI E Cycling tone over the air
1 ONE Radio speaker only
2 CODE ransmit 5s tone fol-lowed by Morse
33 BAND Band Selection 0 – 1 0, VHF
Key Value Notes
0 VHF
1 UHF
34 DR-AB ransmit selection while in 0 – 2 0, Off
Key Value Notes
0 OFF
1 A Upper display
2 B Lower display
35 S E Squelch ail Elimination 0 – 1 1, On
Key Value Notes
0 OFF
1 ON
36 RP-S E Squelch ail Elimination through a repeater 1 – 10 5
37 RP -RL Delay the squelch tail of re-peater 1 – 10 Off
38 PONMGS Power On Message 0 – 1 1, MSG
Key Value Notes
0 FULL Flash entire LCD
1 MSG Displays a 2 line welcome message
39 ROGER Roger Beep
0 – 1 0, Off
Key Value Notes
0 OFF
1 ON

UV-5R Manual
Page 7
40 RESE Restore defaults 0 – 1 1, All
Key Value Notes
0 VFO VFO settings only
1 ALL otal reset*
An ex mple set up for repe ter:
Key in 145115 the NCARC #1 2 Meter repeater
<MENU>25<MENU>2<MENU><EXI >. to set – DUP offset
<MENU>26<MENU>00.600<MENU><EXI >. o set / verify offset frequency
MENU>13MENU>13<MENU>EXI >. Set C CSS transmiter encoder tone
his should allow the use of the 145115 repeater.
Now to store the VFO (Frequency) mode settings into memory
<MENU>28<MENU>1<MENU><EXI >. o clear memory #1
<MENU>27<MENU>1<MENU><EXI >. o set VFO settings into memory #1
You wouldn't have to program very many channels manually and you will find it tedious. I used the multi platform program CHIRP to enter data into radio
MEMORY any or all 125 memory chanels.