Basalte FIBONACCI KNX User manual

Installation Manual
FIBONACCI KNX
© 2020 basalte v1.1
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Description
Fibonacci KNX is a touch-sensitive switch with a unibody design which combines electronics and cover in one
single article.
The separate touch-sensitive surfaces of Fibonacci each control various functions, using both short and long
press.
By touching more than one surface at the same time (multitouch), additional comfort functions can be
activated including room toggle, scene sequencer and RGB sequencer. The multicolour LED backlight provides
status feedback and can be used as night light.
Fibonacci also has a built-in temperature sensor and integrated thermostat logic. A scene controller can
control up to 6 scenes and 8 outputs per scene.
Model No.
0272-02-XX Fibonacci dual KNX
0274-02-XX Fibonacci quad KNX
0272-02-xx 0274-02-xx
Compatible Fibonacci accessories
0272-00 Fibonacci custom dual label set
0274-00 Fibonacci custom quad label set
(*) contact your sales representative to order custom label sets
Fibonacci is designed to be wall mounted in portrait orientation. Fibonacci KNX requires a minimum
in-wall mounting depth of 22mm plus room for cable(s).
A RGB LED
B Programming button
CTemperature sensor
D Programming LED
ELabel back light
DB
CA A
E
E
E

Installation Manual
FIBONACCI KNX
© 2020 basalte v1.1
basalte bv | hundelgemsesteenweg 1A | 9820 merelbeke | belgium
t [phone] | f [phone] | www.basalte.be | [e-mail]
Technical data
Current consumption KNX bus: 30mA
Ambient temperature: Operations between 5 & 45°C
Storage & Transport between 15 & 55°C
Max. humidity: 93% relative humidity - no moisture condensation
Protection Class: II
Type of protection: IP20
Certification: CE
Installation
1. Rough-In
Use a standard European back box or a 1-gang US wall box.
The included mounting bracket should be mounted on the wall box with the included screws.
2. Installing Fibonacci on the wall
Position Fibonacci for portrait mounting (the orientation can be set
in the ETS parameters), align the mounting bracket hooks with the
Fibonacci mounting slots and gently press it towards the mounting
bracket/wall. Fibonacci snaps in when pushed to its mounting bracket.
Powering up Fibonacci
Connect Fibonacci to the KNX bus according to the KNX guidelines.
Load the physical address into the Fibonacci from ETS via the KNX bus.
Commission Fibonacci using ETS and load the configuration into the device
Please refer to the software manual to configure Fibonacci.
Removing Fibonacci
Follow the step 1 and 2 in order to remove Fibonacci from the wall.
1 2
Single-gang box
Mounting
bracket
Dry wall
Push
Pull
a 60 mm (2,36”)
b 84,5 mm (3.33”)
ab
Only use the openings on the vertical axis as shown on the picture.
Don’t screw on the mounting bracket too hard, to avoid bending. This would hinder
proper snapping-in of the keypad.