Bastl Knit Rider User manual

Knit Rider Exander
The Knit Rider exander adds clock OUT and reset INOUT
connections to the Knit Rider seuencer. It doesn't work
without Knit Rider Eurorack module.
instruction

Clock Out outputs a pulse each time a step on the
Knit Rider changes (1 step = 4 substeps). It also has
anindicatior LED.

The Reset socket acts as an output or input, depending
on whether the Knit Rider is master or slave. In master
mode, the reset outputs a pulse each time you press
the start stop button. In slave mode, it acts as an input.
When it detects a pulse, the sequencer goes to its first
step (it will play the first step with the first incoming
clock pulse).

additional feature of this expander is a 3-way passive
multiple with clock inverter. The lower 3 connectors
aresimple passive multiples.

The uppermost connector outputs an inverted version
of the signal in the passive multiple. The inversion is
done with a 2.5V threshold (0V or lower becomes 5V
and 5V and higher becomes 0V).
www.bastl-instruments.com
RESET
CLK OUT
KNIT RIDER EXPANDER
INV OUT
PASSIVE
MULTIPLE





P C B knitt rider
Take it Carefull
connectin the exander
Follow the diagram to connect the ribbon cable to
the Knit Rider. Please make sure the polarity of the
cable is not reversed!
features
 expanding the connectivity of the Knit Rider
Eurorack module
 clock output with indicatior LED
 reset socket can be either output or input,
depending on the master/ slave settings on the Knit
Rider
 3 way passive multiple with clock signal inverter
technical details
2HP
powered from the Knit Rider module
with the expander connected the final current
draw of the Knit Rider is: +12: <40mA
bu this than?
r wife will be...
+12
IN
IN
IN
IN
IN
IN
IN
uni2
uni
-12
GND
red
BASTL-INSTRUMENTS.com
designed and produced in czech republic
+12
IN
IN
IN
IN
IN
IN
IN
uni2
uni
-12
GND
red
BASTL-INSTRUMENTS.com
designed and produced in czech republic
P C B expanderv knitt rider
C
A
B
E
L
S