Baxton Studio FREDA DAYBED-F User manual

NO PART LIST QTY
BACK REST 1PC
SIDE PANEL
(L)
FRONT
SIDE RAIL
LEG
ITEM HARDWARE QTY
JCBB SCREW
M8 x 20MM
L - KEY
M5 x 65MM
1PC
1PC
4PCS
2PCS
14PCS
STEP 1
STEP 2
1
2
3
4
5
F
G
FREDA DAYBED-F/FREDA DAYBED-Q
6
SIDE PANEL
(R)
Please do not tighten the hardware until the entire assembly is completed.
7
8
SLAT 2 SET
JCBC SCREW
M6 x 40MM
SPRING WASHER
FLAT WASHER
L - KEY
M4 x 65MM
SCREW
M4 x 32MM
12PCS
1PC
1PC
H
E
9
A
7pcs
B
CENTER
SUPPORT
SUPPORT
LEG
4PCS
BACK
SIDE RAIL
1PC
1PC
1PC
D
JCBC SCREW
M6 x 50MM
C4PCS
4PCS
4PCS
Begin assembly by attaching each Leg (6) to the
bottom of the Side Panel (2) & (3) securing with
2 Allen Bolt (C) per panel using L-key (G).
Then attach the Back Side Rail (5) to the Side Panel
(2) & (3) by aligning holes and securing with 2
Allen Bolts (A) per each side using L-key (H).
And attach the Front Side Rail (4) also by aligning
holes and securing with 4 Allen Bolts (A) per
side using L-key (H).
(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
Attach the Back Rest (1) to each Side Panel (2) & (3) by aligning
the hole and securing with 2 Allen Bolts (B), 2 Spring Washer (D),
2 Flat Washer (E) as picture below per each end
using L-key (G).
(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
25
43
AH
6CG
2
43
1
5
1
3
EDBG
STEP 1.1
STEP 1.2

STEP 3 STEP 4
STEP 5
Please do not tighten the hardware until the entire assembly is completed.
Secure 2 Support Leg (9) to the Center Support (8) as shown on step 3.1. Tighten the
Support Leg (9) clockwise until secure. Insert the pre-set metal on Center Support (8) to the
metal bracket on each side of Side Panel (2) & (3) as step 3.2. Then securing the metal
bracket as shown in step 3.3 with 1 Screw (F) each side using
Phillips Head Screwdriver (NOT INCLUDED)
Tighten All Bolts from step 1 to step 3 by using L-key (G) & (H) that has been provided.
Attached slat (7) to Front Side Rail (4) & Back Side Rail (5) by unrolling and securing
with 6 Screw (F) per set. Securing Slat (7) to Back Side Rail (5) with 2 Screw (F) as step
4.1. Following by step 4.2, using 1 Screw (F) to secure Slat (7) to Front Side Rail (4).
Repeat the same step to attach another set of slat (7).
ASSEMBLY
COMPLETE
STEP 4.2
STEP 4.1
STEP 3.2
STEP 3.3
STEP 3.1
8
F
8
9
2
3
8
F
7
7
F
7
4
5