BCP SKY2912 User manual

SKY2912
Ver. 2
INSTRUCTION
MANUAL
Wall-Mounted Electric Fireplace

Pg. 2
PARTS
HARDWARE
APPROXIMATELY
45 MIN.
ASSEMBLY
2 PERSON
ASSEMBLY
TOOLS REQUIRED
3V CR2025
LITHIUM BATTERY
(INCLUDED)
123
5 PCS 5 PCS 5 PCS
NO. 6
DRILL BIT ELECTRIC
DRILL
PHILLIPS HEAD
SCREWDRIVER
1 PC
WALL-MOUNTING
BRACKET
1 PC
HEATER
1 PC
TEMPERED GLASS
D
1 PC
REMOTE CONTROL
AB C

Pg. 3
1
Carefully lift and secure the part B heater to the wall bracket, ensuring the
top ledge of heater connects with and is centered with the wall bracket.
PRODUCT ASSEMBLY Please retain these instructions for future reference.
• Mark the location where the screws will go into the wall. Use an electric drill with a no. 6 drill bit to
drill five holes.
NOTE: It is recommended to use a level to ensure holes are drilled at an even height.
Insert five part 3 wall anchors into the drilled holes.
Attach the part A wall-mounting bracket to the wall anchors with five part 2 screws.
1
2
A
A
Do not ax this appliance at a height lower than 1 ft. from the floor (at least 2 ft. recommended), or higher than
3.5 ft. from the ceiling.
2
3
B

Attach the sides of the wall bracket to the heater with two part 1 screws, one on each side.
3
Pg. 4
Align the part C tempered glass over the front of the unit. Make sure the slots in the bracket on the
sides of the glass panel align with the lugs on the side of the heater.
4
BACK
B1
BC

HEATER/FIREPLACE OPERATION
• This appliance has a safety-cut o that will engage if the fireplace overheats. The fireplace will NOT automati-
cally reset for safety reasons. To reset the appliance, unplug the unit for 15 minutes and then plug it back in.
• This appliance can be controlled by the panel on the unit or the remote.
•Do not press the buttons more than once in two seconds; it takes some time for the fireplace to respond.
F
ON/OFF DIMMER HEAT TEMP TIMER
• ON/OFF: Turn the heating/display eect on and o.
• DIMMER: Controls the brightness levels. Press to cycle through 5 dimness levels and the OFF setting.
• HEAT: Controls the heating level. Press to cycle through the low setting (750W), high setting (1500W), and the
OFF setting.
• TEMP: Controls the temperature level. Press to cycle through the heat levels, ranging from 62°F to 82°F, and the
OFF setting.
• TIMER: Controls the automatic timer. Press to cycle through timer options—1 hour through 8 hours—and the
OFF setting.
• STANDBY SWITCH: Press to toggle standby on/o. This must be switched on to use the heater/fireplace.
5
Carefully lower the tempered glass onto the lugs.
Pg. 5
Secure glass to the heater with three part 1 screws.
6
BACK
B
C
1
C

CARING FOR YOUR HEATER
• Turn unit o and unplug before any maintenance. Wait at least 10 minutes after unplugging before cleaning or
maintenance.
• Use a vacuum/duster to keep vent area and heater clear of debris and dust.
• Fireplace exterior should be cleaned with a damp cloth or duster.
• Do not use abrasive cleaners or liquids.
REPLACING BATTERIES
• Press the release and slide open the back panel of the remote.
• Remove the battery.
• Insert a brand new CR2025 battery, ensuring the “+” and “-” signs are arranged correctly.
• Replace back panel.
REMOTE CONTROL OPERATION
The remote has a 3V CR2025 lithium cell battery included. Remove the slip between the battery and contacts
before operating the remote.
1. ON/OFF
2. °F – Adjust temperature settings
3. DIMMER – Adjust dimmer settings
4. HEAT – Adjust heat settings
5. TIME – Adjust timer settings
ON/OFF ºF
HEATDIMMER
TIME
RELEASE
Pg. 6

NOTICE
• Please read through all instructions before mounting and using this fireplace.
• This fireplace is designed to mount onto the wall and not recessed within a wall.
• This product should be wall-mounted at least 1 ft. above the ground. A 2 ft. height is recommended.
• There should be at least 3.5 ft. clearance between this product and the ceiling.
• The wall bracket on this product should only be fit horizontally.
• The cable should only be routed to the bottom right of the heater.
• Only use this heater with an AC power supply with the correct voltage.
• Do not plug in other devices into the same circuit.
• Do not turn the appliance on until it is properly installed.
• Do not leave appliance unattended during use or when plugged in.
• Do not let children operate or go near this appliance.
• Do not let children or small pets near during mounting and installation.
• Do not operate this product if the cord or any parts of this appliance are damaged. Do not attempt to modify
the cord.
• Periodically check the cord and appliance for damage.
• Do not run cord under rugs, furniture, etc.
• Do not allow cord to hang over sharp edges or place near hot surfaces.
• Do not cover or obstruct the heater in any way.
• Never immerse this appliance or cord in water or any other liquids.
• Do not attempt to replace the LED bulbs. Only a licensed and qualified electrician should do so.
• Repairs to this appliance should only be performed by a licensed and qualified electrician.
• Do not attempt to open the back panel unless the electricity is turned o.
• Disconnect and discontinue use of this appliance if any water damage occurs, or if the unit becomes hot to the
touch, broken, or smokes/smells like smoke.
• Do not dispose of this appliance as unsorted waste. Use special collection facilities for electrical appliances.
• NOTE: When the heat function is turned on for the first time, a slight odor may be present. This is normal and
should not occur again.
SPECIFICATIONS
Power Supply
Rated Power
120 V/60 Hz
750 W/1500 W
WARNINGS REGARDING BATTERIES
• Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
• Do not mix old and new batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged under adult supervision only.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.
Pg. 7

All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long as the
item is returned in its original product packaging and all accessories from its original shipment are included. All
returned items will receive a full refund back to the original payment method. All returned items will not be charged
a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best Choice
Products Customer Service Representative when the return request is submitted. Items received without an RA
may not be accepted or may increase your return processing time. Once an item has been received by Best Choice
Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If the
reason for return is a result of an error by Best Choice Products then Best Choice Products will provide a pre-paid
shipping label via email. Boxes for return shipping will not be provided by Best Choice Products, and is the
customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items returned are
not considered undamaged until they are received by Best Choice Products and verified as such. All damages to
items are the customer’s responsibility until the item has been received by and acknowledge by Best Choice
Products as undamaged.
CONTACT US; WE’RE HERE 7 DAYS A WEEK TO HELP YOU!
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
PRODUCT WARRANTY INFORMATION
bestchoiceproducts.com customerservice@
bestchoiceproducts.com 844.948.8400 LEARN MORE!
ENJOY YOUR NEW FIREPLACE!