BEA LPS-A6 User manual

INSTALLATION GUIDE
INSTALLING THE LPS-A6 POWER SUPPLY MO-
DULE IN THE EVERSOLO DMP-A6 / DMP-A6
MASTER EDITION

Tools required:
• LPS-A6 power supply kit
• EverSolo DMP-A6 / DMP-A6 Master Edition
• Phillips screwdriver
• Allen key 2.0mm

Step 1: Use a 2.0mm allen key to unscrew the 6 screws on the rear panel and the 7
screws on the underside of the unit. Total screws to remove: 13.

Step 2: Gently slide the device cover outwards about 20mm. Two webs connect
the screen to the motherboard. Don’t use too much force.

Step 3: Lift and tilt the cover (gently). Caution: cables are attached to the cover,
screen and motherboard. Do not undo them.

Step 4: Identify the switch mode power supply (SMPS) of the DMP-A6.

Step 5: Disconnect the jumper cable. This is a latched connector. Press the central
part to unlock it, then pull it gently upwards.

Step 6: Use a Phillips screwdriver to remove the 6 screws securing the switching
power supply.

Step 7: Remove the switching power supply module from the DMP-A6 and prepare
the LPS-A6 module.

Step 8: Locate the insulation rings (4 pieces). Place them on the PCB spacers as
shown in the following photos.