BEATNIC MIDI-IF User manual

MIDI-IF for SX-150mk2
Owner's Manual
Connection
T pe 1 : getting sound from SX-150mk2 T pe 2:getting sound from output
Standard connection is Type 1. You can get SX-
150mk2's sound from SX-150mk's small speaker.
En oy its sound anywhere you want. When you want
to get more loud or use SX-150 in your recording
session, Type 2 is recommended.

Parameters
MIDI-IN
put MIDI out here. MIDI-channel can be accepted
only 1.
Mini plug for SX150
Put it "Line In" in or output of SX150.
When you want to get sound from small speaker
of SX150 mk2 then connect it to "Line In".
Or you need more loud sound, plug it to SX-150's
"output". the signal may appear on standard ack
at the MIDI-IF. you can use standard cable for
guitar or something. put it to Guitar amp or so.
St lus jack
Put it the stylus of SX-150mk2 to drive it.
OUT(jack)
This ack is ust only connected to 3.5mm plug.
you can ust use it as plug size conveterter from
3.5mm (mini plug) to 6.2mm (standard plug).
Power Switch
Power switch.
Glide
You can get glide effect on pitch.
Rate
You can get the vibrate by moving modulation
wheel at your MIDI key board (#CC 1).
it change the depth of vibrate.This knob change
its depth.
Tune
For Setting the tune of SX-150mk2
Wave shape
Change the wave form of the vibrate. Triangle /
Squre wave can be selected.
Tune Switch
This is pitch tuning support function. Pushing
this button, you can hear center "A" sound
(220Hz) from Output ack or mini plug. when
you put mini plug into "Line In" of sx-150, you
can also hear the sound of sx-150 itself. so turn
Tune knob and get the tune right.
Maintenance
When battery low, Open box and change it. It's 006p
(9V Type). Check + / – sleeve. Beware not to
connect wrong way.
MIDI-IF for SX-150mk2
Owner's Manual
Apl-08, 2015 Fisrt edition
Copyright beatnic. p 2015