Always use two people when
setting up the base.
Place the bed base box in
a desired location with the
bottom of the box facing up.
Remove the binding straps
and packing materials, making
sure not to puncture the box
with any sharp objects.
If installing a headboard, please see headboard bracket installation
instructions in Owner’s Manual.
See Owner’s Manual for complete operating instructions.
PART LIST
Before discarding the packing materials- ensure all the parts are accounted for.
Some parts may be attached to the base or inside boxes, please inspect carefully.
PART LIST
*King bases will have a spare processor and 5v DC Power
BASE SETUP
Sleeptracker® SETUP
(1) Wireless
Remote
(3) AAA
Batteries
(4) Legs &
Washers
(1) Power
Cord
(1) Power
Supply
(1) Power
Down Box
Optional Equipment:
(not included)
• Surge Protector
• (2) 9V Batteries
Only included in split bases:
(1) Connecting
Strap
(1) SmartSync®
Cord
To sync two bases with the SmartSync™ cord - see installation
instructions in Owner’s Manual
Uncoil the Power Down Box from the frame
and install (2) 9 Volt batteries- not included.
Place box on the ground. Ensure that it is
easily accessible when the base is turned to
its upright position.
Uncoil input cord (connected to control
box’s power port) and plug into Power
Supply.
Install the legs by threading
the washer over the bolt of
the leg with the recessed side
facing the leg, and tighten by
hand. Do not over tighten.
Install (3) AAA batteries in remote control.
Quickly test functions to verify proper setup
before placing mattress on base. Press FLAT to
return the base to a flat position.
Carefully flip the base over on to its legs. Important: Two people
are required to move the bed base. Do not drag across the floor.
Do not rest frame on its side, excessive pressure may damage the
legs.
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector.
Plug the base and into a power source. A surge protector is
strongly recommended.
Place the mattress on the base.
Select Beautyrest® mattresses* are
compatible with the mattress retainer
attachment panel installed on the
SmartMotion™ bases
Test all functions on the base to ensure proper setup. For more information please see Owner’s Manual
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
*If the mattress is not
compatible with the
attachment panel, a mattress
retainer bar is available for
purchase at: 1-888-550-3746
STEP 1STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 2
STEP 3
Please refer to Beautyrest Quick Start Guide for
Sleeptracker® download and setup instructions.
Visit help.beautyrest.com from your smartphone to download
the app and view additional Sleeptracker® product information.
QUEEN TWIN
KING
