Minerva 3108 User manual

*Open all boxes to check for parts
before beginning assembly.
2
1
3
Place the desktop front
piece on the desk. Using
one of the long bolt and
washer per side, go in
through the opening
shown and screw up
through the bottom to
secure the section.
drawer
guide X6
hardware
single
long bolts X8
w/ washers
Place the desktop side pieces
on the desk with the holes lined up.
Using one of the long bolt and
washer per side, go in through the
opening shown and screw up the
the bottom to secure the section.
Parts List: Six desk sections, three drawers, and the hardware below:
double
sided bolts X8
w/ washers
small
phillips X~100
screws
#3108 Elevate Reception Desk
Assembly Instructions Line up the desk sides to the middle. Use four double-sided
bolt and washer sets to connect the sides through the holes
shown here.

5
6
4
7
Use three small screws to attach each of the inner pieces
of the drawer guides to the sides of the drawers.
Open the doors on the side pieces. Use 2 long bolts and
washers to connecteach side to the desktop front piece.
Extend the drawer guides and remove the innermost piece
by pushing and holding the tab and sliding the piece out.
(some tabs need to be pushed up and some down.)
Screw the larger parts of the drawer guides inside
where the drawers go. Slide drawers into place.

If there is any confusion
please contact Minerva's
customer service
department at:
888-332-0123
We will be
happy to answer any
questions.
Thanks for choosing
Minerva Beauty!
Assembley complete.
Enjoy your new reception desk!