
bebob factory GmbH – Höglwörtherstr. 350 – D-81379 München – Tel.: +49 89 27818282
www.bebob.de
November 2019
Charging
•Never load unattended
•Wait 30 Minutes after discharge before you put the battery on a charger.
•The bebob A200 battery can be charged with an external bebob charger (or equivalent)
with Lithium-ion (Li-ion) charging ability.
•Approximate charge time may vary depending on charger and temperature.
•bebob A200 can be charged in ambient temperature for optimum performance at 10°C -
30°C.
•bebob A200 batteries can be recharged in any charge condition.
Discharging
•Maximum load is 16.0A. When using the battery with video or lighting equipment, power
consumption of the equipment must be 16.0A or below. For the protection of the battery, a
load of 16.0A or over may activate the internal protection circuit and stop supply of power.
In this case the Fuse will self-rest after a couple of minutes
•The battery can be used in ambient temperature of - 20°C - + 55°C.
Storage
•Storage temperature range is - 20°C ~ + 35°C (<85% humidity).
•To store the battery for a long period (longer than 4 Weeks), the battery should be charged
between 50% and 75%. The battery should be recharged every 4 Weeks.
•After storage some self-discharge will occur. Before re-use it is advisable to recharge the
battery fully.
Warranty
•The A200 is covered by a 2 years unconditional warranty on all parts, except the cells.
•The cells are covered by a 1 year warranty, 70% of the original capacity.
•For warranty issues or if you have any additional questions, please contact the appropriate
bebob distributor listed at www.bebob.de.
Disposal
•The A200 battery has to be disposed within a dedicated collection container for used
device batteries. Please be aware that only empty batteries are allowed for disposal in
collection containers. In case the battery is not completely discharged, precautions against
a potential short-circuit have to be taken.