
bebob factory GmbH – Höglwörtherstr. 350 – D-81379 München – Tel.: +49 89 27818282
www.bebob.de
November 2019
Charging
•Never leave batteries unattended while charging
•Wait 30 Minutes after discharge before you put the battery on a charger.
•The bebob V290RM CINE battery can be charged with an external bebob charger (or
equivalent) with Lithium-ion (Li-ion) charging ability.
•Approximate charge time may vary depending on charger and temperature.
•bebob V290RM CINE can be charged in ambient temperature for optimum performance at
10°C - 30°C.
•bebob V290RM CINE batteries can be recharged in any charge condition.
Discharging
•Maximum load is 20.0A (over bebob Vcine Mount only). When using the battery with video
or lighting equipment, power consumption of the equipment must be 20.0A or below. For
the protection of the battery, a load of 20.0A or over may activate the internal protection
circuit and stop supply of power. In this case the Fuse will self-rest after a couple of
minutes
•The battery can be used in ambient temperature of - 20°C - + 55°C.
Storage
•Storage temperature range is - 20°C ~ + 35°C (<85% humidity).
•To store the battery for a long period (longer than 4 Weeks), the battery should be charged
between 50% and 75%. The battery should be recharged every 4 Weeks.
•After storage some self-discharge will occur. Before re-use it is advisable to recharge the
battery fully.
Warranty
•The V290RM CINE is covered by a 2 years unconditional warranty on all parts, except the
cells.
•The cells are covered by a 2 year warranty, 80% of the original capacity.
•For warranty issues or if you have any additional questions, please contact the appropriate
bebob distributor listed at www.bebob.de.
Disposal
•The V290RM CINE battery has to be disposed within a dedicated collection container for
used device batteries. Please be aware that only empty batteries are allowed for disposal
in collection containers. In case the battery is not completely discharged, precautions
against a potential short-circuit have to be taken.