Bedford 2 Door HMR Base Cabinet User manual

ASSEMBLY GUIDE
HMR Solutions
2 Door HMR Base Cabinet
IMPORTANT
Before commencing Assembly:
•Read all instructions COMPLETELY.
•Hardware kit contains small parts; keep out
of reach of children.
•Ensure all listed parts are present.
•Required tools to assemble:
Philips head screw driver, Hammer & Wood
Glue.
•Required assembly work surface should
be solid, level, clean and flat.
•Ensure all melamine edges are facing to the
front of the unit.
Customer Services Enquiries 1800 822 823
Controlled Document 9.2.4.11
Revivision 3
TP05-146

A
x4 B
x4 D
x12
C
x8 F
x2
E
x12
G
x8 K
x4
H
x4 J
x12 L
x25
E
E
E
D
D
D
E
E
E
E
E
D
I
x1
C
C
CC
H
H
H
G
G
G
H
G
G
G
G
G
Controlled Document 9.2.4.11
Revivision 3
TP05-146

D
D
D
D
E
E
E
Front Edge
58.50
E
Controlled Document 9.2.4.11
Revivision 3
TP05-146

B
B
B
B
L
K
FK
J
Screw 1
Screw 2
Screw 1 is used for adjustment•
Screw 2 is used to secure hinge to•
end
The following instructions show how to
adjust hinges if the gap between the doors
is too wide.
Start from the top hinge. Loosen1.
screw 2 by turning screw in an anti-
clockwise direction.
Now turn screw 1 in a clockwise2.
direction (the amount to turn this
screw is determined by the width of
the gap between the doors).
Tighten screw 2 by turning in a3.
clockwise direction.
Repeat these steps for the centre4.
hinge and bottom hinge.
Repeat these steps again with the5.
other door.
Check gap between doors (should be6.
approx 2mm), if not repeat steps 1 to
5.
Controlled Document 9.2.4.11
Revivision 3
TP05-146