Bedford HMR Solutions User manual

ASSEMBLY GUIDE
HMR Solutions
2 Door Split Cabinet 600mm
IMPORTANT
Before commencing Assembly:
•Read all instructions COMPLETELY.
•Hardware kit contains small parts; keep out
of reach of children.
•Ensure all listed parts are present.
•Required tools to assemble:
Philips head screw driver, Hammer & Wood
Glue.
•Required assembly work surface should
be solid, level, clean and flat.
•Ensure all melamine edges are facing to the
front of the unit.
Customer Services Enquiries 1800 822 823
Controlled Document 9.2.4.11
Revision 2
TP05-145

F
M
I
x1
H
x4L
x25
K
x4
J x12
x8
x2
H
G
G
H
H
G
G
H
D
D
D
D
D
D
D
D
x12
E
E
E
E
E
E
E
G
x4
A
x6
B
x4
C
x12
x12
D
N
x4
O
x4
Controlled Document 9.2.4.11
Revision 2
TP05-145

C
C
C
CC
C
N
N
O
O
NO
J
J
Controlled Document 9.2.4.11
Revision 2
TP05-145

L
K
K
F
B
square before
B
nailining back panel.
B
Caution:
Ensure cupboard is
Screw 1
Screw 2
B
•
Screw 1 is used for adjustment
•Screw 2 is used to secure hinge to
end
The following instructions show how to
adjust hinges if the gap between the
doors is too wide.
1. Start from the top hinge
2. Loosen screw 2 by turning screw
in an anti-clockwise direction.
3. Now turn screw 1 in a clockwise
direction (the amount to turn this
screw is determined by the width
of the gap between the doors).
4. Tighten screw 2 by turning in a
clockwise direction
5. Repeat these steps for the centre
hinge and bottom hinge
6. Repeat these steps again with the
other door
7. Check gap between doors
(should be approx 2mm), if not
repeat steps 1 to 5.
Controlled Document 9.2.4.11
Revision 2
TP05-145