Twsit av stand Setup guide

TWIST
AV STAND
product set up instructions
19968

Twist AV Stand Setup Instructions

Twist AV Stand Setup Instructions
Place the AV base on the oor. Place a TWIST base over the AV base locating
uprights and manoeuvre the TWIST base socket into
position.
Slide the bottom AV uprights (orange xing) on to the AV base, and tighten the
orange screws.
1
3
2
WARNING: Please ensure
orange screws are loosened fully
before placing on the base, to
prevent the screws resting on
top of the locating uprights.
!

Twist AV Stand Setup Instructions
Place the next section of AV upright onto the locating pin and slide a locking pin between the joint and tighten.
Locate the AV crossbeam into position and tighten the
locking pins.
4
5

Twist AV Stand Setup Instructions
6 7
Continue to build the TWIST stand; making sure that
the TWIST upright sits behind the AV crossbeam.
8
Once you have attached the brackets provided to the
TV/Monitor screen, manoeuvre the screen into position
so that the two brackets sit on top of the crossbeam.
Once the screen is in position, further alterations can
be made for cables if required. Then hook the graphic
to the base.
WARNING: Please check the TV vesa mounting holes
for compatability.
Vesa mounting holes: AV 200:
100mm x 100mm
200mm x 200mm
AV 400:
400mm x 200mm
400mm x 400mm
Then hang the graphic.
But dont hook the bottom of the graphic until
the screen has been positioned on the AV Stand.
!
!

Twist AV Stand Setup Instructions
9
The AV stand complete.