Bedford WS-1200mm User manual

9.2.4.11 Revision 1 TP05-159
ASSEMBLY GUIDE
WS-1200mm 2 Door Robe
IMPORTANT
Before commencing assembly:
Follow all instructions COMPLETELY
Hardware kit contains small parts; keep out
of reach of children.
Ensure all listed parts are present.
Required tools to assemble:
Phillips head screw driver, Hammer & Wood
Glue (optional for extra strength).
Required assembly work surface should
be solid, level, clean and flat.
Ensure all melamine edges are facing to the
front of the unit.
Two person assembly required.
Do not stand the unit upright until the
back panel has been nailed on, otherwise,
the unit may collapse.
Detailed instructions are available by
visiting:
http://www.bedfordfurniture.com.au/
Customer Services Enquiries 1800 822 823

9.2.4.11 Revision 1 TP05-159

9.2.4.11 Revision 1 TP05-159
`

9.2.4.11 Revision 1 TP05-159

9.2.4.11 Revision 1 TP05-159

9.2.4.11 Revision 1 TP05-159

9.2.4.11 Revision 1 TP05-159

9.2.4.11 Revision 1 TP05-159
Screw 1 is used for adjustment
Screw 2 is used to secure hinge to hinge plate
The following instructions explain hinge
adjustment if gap between the doors is too wide:
1. Start from the top hinge
2. Loosen screw 2 by turning screw in an anti-
clockwise direction.
3. Now, turn screw 1 in a clockwise direction
(the amount to turn this screw is determined
by the width of the gap between the doors).
4. Tighten screw 2 by turning in a clockwise
direction
5. Repeat this step for all the hinges.
6. Check gap between doors (should be
approximate 2mm), if not repeat steps 1 to 5.
It is strongly recommended to secure the unit to the wall, otherwise, it may tip forward when opened empty.