1-Remove Lens / Diffuser
3-Remove Mounting Hardware Kit
2-Remove Reflector
5-Fixture Body Mounting
6a-Electrical Connections
Exact ballast and wiring configuration
may differ from image above:
FOLLOW ACTUAL WIRE LABELS.
Labeled wireleadsareprovided for
Line / Hot, Neutral / Common andGround.
Labels will indicate the rated input voltage:
120-277VAC or 347VAC 60Hz.
LN
B A L L A S T
Line / Hot
L
Neutral / Common
N
Ground
7-Install Lamp 8-Install Lens / Diffuser
ceiling mount
wall mount
suspension mount
4-Install Mounting Hardware
49 3/4
35 1/2”
6-Hang Reflector From Internal Clips
and Connect AC Supply
Important Safeguards Installation
Whenusing electrical equipment,basic
safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
Do not let power cords touch hot surfaces.
Do not mount near gas or electric heaters.
Equipment should be mounted inlocations
and at heights where unauthorized personnel
will not readily subject it to tampering.
The use of accessory equipment not recommended
by Beghelli Inc, may cause anunsafe condition,
and will void the unit’s warranty.
Do not use this equipment for other than its
intended purpose.
Servicing of this equipment should be
performed by qualified service personnel.
SAVE THESE INSTRUCTIONS!
Remove Lens / Diffuser.
Remove the reflector
Remove the mounting hardware bag.
Securely mount the fixture hardware
The fixture can be snapped onto
the hardware as illustrated.
Pass AC power wires through previously
drilled holes(s) and connector(s).
Hang Reflector From Internal Clips
Connect AC supply and ground as labeled
on the provided wire leads.
Insulate unused wire!
CAUTION! Failure to insulate unused
wire may result in a shock hazard or
unsafe condition as well as equipment
failure.Route wires and secure them in place.
Install the lamp into the lamp holder and
turn to lock it into place.
Install closure clips. Replace the lensand
snap each of the eight (8) clips into place
Turn on AC voltage
9.
8.
7.
6.
5.
4.
3.
2.
1.
reinstall reflector
